Extreme Networks EW0-300 Online Practice Questions and Exam Preparation

Extreme Networks EW0-300 Online Questions & Answers

• Question 41:

  Which of the following CLI commands could you use to determine which ports are enabled for ESRP host attach?

  A. show ports info detail
  B. show esrp detail
  C. show esrp
  D. show ports config
  B. show esrp detail

• Question 42:

  Health checking is used in SLB to determine the health of nodes by activity poling these nodes. The default health check called ping-check will keep working when the switch has an active access-list denying ICMP echo replies.

  A. True
  B. False
  B. False

• Question 43:

  Which CLI command configures DVMRP on all IP multicast interfaces.

  A. config dvmrp add vlan all
  B. config dvmrp add all
  C. enable dvmrp
  D. enable dvmrp vlan all
  A. config dvmrp add vlan all

• Question 44:

  IS-IS routing uses two levels of hierarchical routing level 1 and level 2. A level 1 router has full knowledge of the topology in the whole routing domain in a network with multiple areas.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 45:

  IGMP v1 supports the leave group message.

  A. True
  B. False
  B. False

• Question 46:

  Virtual links are always configured to be a necessary part of all OSPF networks using Extreme's Summit 48i switches.

  A. True
  B. False
  A. True

• Question 47:

  The CLI Command configure ospf delete vlan all? Will do the following on an Extreme switch.

  A. delete all the vlans from Area 0
  B. delet all OSPF areas configured on the switch
  C. disable OSPF globally on the switch
  D. disable the OSPF routing protocol on all the VLANs
  D. disable the OSPF routing protocol on all the VLANs

• Question 48:

  What does the abbreviation PIM stands for?

  A. Protocol Implicit Multicast
  B. Protocol Independent Multicast
  C. Port Independent Multicast
  D. Port Implicit Multicast
  B. Protocol Independent Multicast

• Question 49:

  Is it possible on a single switch, to put different physical ports, belonging to the same VLAN, into different STPD's?

  A. No, this is not possible.
  B. Yes, this is possible.
  C. This is only possible when these ports are in EMISTP mode.
  D. This is only possible when these ports are in 802.1D mode.
  B. Yes, this is possible.

• Question 50:

  In OSPF, when you configure an Extreme switch with router priority of 0, what happens?

  A. The router becomes a Backup Designated Router
  B. The router becomes a Designated Router
  C. The router will not participate in the DR election algorithm
  D. Nothing because router priority 0 is the default setting for router priority
  C. The router will not participate in the DR election algorithm