Extreme Networks EW0-100 Online Practice Questions and Exam Preparation

Extreme Networks EW0-100 Online Questions & Answers

• Question 81:

  

  Which predefined protocol filter does the following information relate to?

  DECNET

• Question 82:

  In unicast IP routing, all forwarding decisions are based on the ______ of each packet.

  A. destination MAC address
  B. source IP address
  C. source MAC address
  D. destination IP address
  D. destination IP address

• Question 83:

  How many Extreme Networks switches can be grouped together to make a single ESRP virtual router?

  A. 2
  B. 3
  C. 4
  D. 5
  A. 2
  B. 3
  C. 4

• Question 84:

  Which commands would you use to configure an ESRP domain with VLAN HQ as the super- ESRP-VLAN and VLAN floor-1 as the sub-ESRP-VLAN?

  A. config vlan floor-1 add domain-member vlan hq
  B. config vlan hq add domain-member vlan floor-1
  C. config domain-member vlan hq vlan floor-1
  D. config domain-member vlan floor-1 vlan hq
  B. config vlan hq add domain-member vlan floor-1

• Question 85:

  A MAC address may not be present in more than one VLAN.

  A. True
  B. False
  B. False

• Question 86:

  A QoS profile determines into which hardware queue a frame is assigned.

  A. True
  B. False
  A. True

• Question 87:

  Which of the following commands could you use to determine which ports are enabled for ESRP host attach?

  A. show ports info detail
  B. show esrp detail
  C. show esrp
  D. show ports config
  B. show esrp detail

• Question 88:

  ESRP can simultaneously protect a maximum of __________ VLANs per switch.

  64

• Question 89:

  Which RIP settings are enabled by default?

  A. Triggered updates
  B. Poison Reverse
  C. Split Horizon
  D. Route redistribution
  A. Triggered updates
  B. Poison Reverse
  C. Split Horizon

• Question 90:

  After adding all VLANs to STPD s0 you are unable to move VLAN corporate to STPD s1. What steps must you take for this to happen?

  A. Delete all ports associated with VLAN corporate, add VLAN corporate to STPD s1,add all necessary ports to VLAN corporate.
  B. Delete all ports associated with VLAN corporate, add VLAN corporate to STPD s1,reboot the switch, add all necessary ports to VLAN corporate.
  C. Disable STP for VLAN corporate, add it to STPD s1, and then enable STP for VLANcorporate.
  D. Disable STP for VLAN corporate, add it to STPD s1, reboot, then enable STP forVLAN corporate.
  A. Delete all ports associated with VLAN corporate, add VLAN corporate to STPD s1,add all necessary ports to VLAN corporate.