Extreme Networks EW0-100 Online Practice Questions and Exam Preparation

Extreme Networks EW0-100 Online Questions & Answers

• Question 31:

  Which of the following can you use to create a router interface?

  A. Create a VLAN and assign ports to it.
  B. Create a VLAN and enable loopback mode.
  C. Create a VLAN, assign ports to it, and assign an IPX net ID.
  D. None of these.
  C. Create a VLAN, assign ports to it, and assign an IPX net ID.

• Question 32:

  Which command would you use to create a blackhole route that blocks traffic to the 10.0.0.0/8 network?

  A. config iproute add 10.0.0.0/8 blackhole
  B. config blackhole iproute add 10.0.0.0/8
  C. config iproute add blackhole 10.0.0.0/8
  D. None of these.
  C. config iproute add blackhole 10.0.0.0/8

• Question 33:

  An Ethernet broadcast domain is equivalent to a __________ within the switch.

  VLAN

• Question 34:

  How would you change the password for John Doe's management account?

  A. Enter config jdoe and then enter the new password twice.
  B. Enter config jdoe user account and then enter the new password twice.
  C. Enter config user account jdoe and then enter the new password twice.
  D. Enter config account jdoe and then enter the new password twice.
  D. Enter config account jdoe and then enter the new password twice.

• Question 35:

  Internal routers within an OSPF area are either DRs, BDRs, or __________.

  ODR

• Question 36:

  When using Spanning Tree Protocol, ExtremeWare permits VLANs in different STPDs to share the same port when tagged.

  A. True
  B. False
  B. False

• Question 37:

  STPDs s0, s1, and s2 have been created. How would you activate only s1 while leaving the other STPDs inactive?

  A. enable stpd s1
  B. enable s1 stpd
  C. None of these
  A. enable stpd s1

• Question 38:

  In OSPF, ASBRs are only supported by NSSAs.

  A. True
  B. False
  B. False

• Question 39:

  Which of the following is the default ESRP priority setting?

  B. 1
  C. 254
  D. 255
  A

• Question 40:

  The __________ command is used to view Spanning Tree Protocol domain configuration settings. Do not abbreviate the CLI command.

  show stpd