EMC E20-616 Online Practice Questions and Exam Preparation

EMC E20-616 Online Questions & Answers

• Question 71:

  A CE is dispatched to replace a Drive. After logging into a Symmetrix VMAX 40K running Enginuity 5876.159.102 Simplified SymmWin is automatically launched. How should the CE proceed?

  A. Select Service Request Number then click Run Task
  B. Close Simplified SymmWin and select SymmWin from the desk top, then select Procedure Wizard
  C. Log off then log on using a Break Fix Credential
  D. Simplified SymmWin does not support VMAX 40K
  A. Select Service Request Number then click Run Task

• Question 72:

  Which component is used to connect the Service Processor to the Engines?

  A. Management Module
  B. System Interface Board
  C. USB Port
  D. Messaging Interface Board Enclosure
  A. Management Module

• Question 73:

  What is the maximum number of High Density Storage bays that can be configured in a VMAX 40k?

  A. 8
  B. 10
  C. 6
  D. 4
  A. 8

• Question 74:

  Which SRDF/A feature offloads from cache to a dedicated device pool?

  A. Delta Set Extension
  B. Write Pacing
  C. Transmit Idle
  D. SRDF Compression
  A. Delta Set Extension

• Question 75:

  A CE is currently installing a VMAX 40K. Where should the light panel cables of the System Bay be connected?

  A. Engine 4
  B. 1st AC slot
  C. Engine 5
  D. 2nd AC slot
  A. Engine 4

• Question 76:

  Refer to the Exhibit.

  

  You are implementing ESRS. Into which Ethernet port do you plug the IP cable?

  A. 8
  B. 7
  C. 6
  D. 5
  A. 8

• Question 77:

  You installed Symmwin on your service laptop. You tried to run the command A7,C to verify the status of the devices, but the Inlines icon is disabled. What needs to done to successfully complete this activity?

  A. Move to the VMAX service processor.
  B. Log in with the Engineering account.
  C. Use the Tools menu dropdown and choose Inlines.
  D. Change the access level to Expert.
  A. Move to the VMAX service processor.

• Question 78:

  A director replacement is required on VMAX 20K. The customer asks what the impact will be on the front- end ports of the director being replaced. What should your response be?

  A. The front-end I/O modules will go offline.
  B. The front-end I/O modules will use a redundant Virtual Matrix.
  C. The front-end I/O modules will use redundant SIB.
  D. The front-end I/O modules will remain online.
  A. The front-end I/O modules will go offline.

• Question 79:

  What is the status of the R1 and R2 devices after a SRDF Failback operation is performed?

  A. R1 is Read-Write R2 is Write Disabled
  B. R1 is Write Disabled R2 is Read-Write
  C. R1 is Read-Write R2 is Read-Only
  D. R1 is Read-Only R2 is Read-Write
  A. R1 is Read-Write R2 is Write Disabled

• Question 80:

  What is required to create Dynamic SRDF Groups?

  A. Switch Connectivity
  B. Ethernet Connectivity
  C. LAN Connectivity
  D. WAN Connectivity
  A. Switch Connectivity