EMC E20-351 Online Practice Questions and Exam Preparation

EMC E20-351 Online Questions & Answers

• Question 151:

  On an MDS-Series switch, if a VSAN containing ports is deleted, what happens to the ports?

  A. The ports are moved to VSAN 4094 and are shut down.
  B. The ports do not belong to any VSAN and are shut down.
  C. The ports move to VSAN 1 and are shut down.
  D. The ports move to VSAN 1 and remain active.
  A. The ports are moved to VSAN 4094 and are shut down.

• Question 152:

  Which information will be displayed when viewing the Node List from Connectrix Manager?

  A. Port Number, FCID
  B. Port Number, Zone
  C. Port Speed, FCID
  D. Port Speed, Zone
  A. Port Number, FCID

• Question 153:

  Which layer of the ARPA architecture does Ethernet represent?

  A. Application layer
  B. Network Interface layer
  C. Network layer
  D. Transport layer
  B. Network Interface layer

• Question 154:

  When would the domain of VSAN 5 change upon issuing the command fcdomain domain 3 static vsan 5 for an MDS switch?

  A. After saving the running configuration to start up configuration
  B. Immediately
  C. When members were added to the VSAN
  D. When the VSAN was restarted
  D. When the VSAN was restarted

• Question 155:

  Which bits contain the Area Address in a Fabric Channel address?

  A. First set of 8 bits
  B. Fourth set of 8 bits
  C. Second set of 8 bits
  D. Third set of 8 bits
  C. Second set of 8 bits

• Question 156:

  When configuring a VSAN on an MDS-Series switch, multiple switches can be added to a VSAN in one step using which MDS-Series management tool?

  A. MDS-series Manager
  B. Device Manager
  C. Fabric Manager
  D. VSAN Manager
  C. Fabric Manager

• Question 157:

  To restore the configuration of a B-Series switch, which command is used?

  A. configDownload
  B. configUpload
  C. firmwareUpload
  D. restoreConfig
  A. configDownload

• Question 158:

  In which situation does the Fibre Channel protocol reach data rates up to 10 GB/s?

  A. When FC data is sent over IP through a multiprotocol router
  B. When used as ISLs (E_Ports) on all switches
  C. When used as ISLs (E_Ports) on supported switches
  D. When used in a CAS environment (content addressed storage)
  C. When used as ISLs (E_Ports) on supported switches

• Question 159:

  Which Fibre Channel layer is responsible for Process Logins?

  A. FC-1
  B. FC-2
  C. FC-3
  D. FC-4
  D. FC-4

• Question 160:

  When installing EMC PowerPath on a Linux host, which command will initiate the install?

  A. installp
  B. pkgadd
  C. rpm
  D. swinstall
  C. rpm