EMC E20-340 Online Practice Questions and Exam Preparation

EMC E20-340 Online Questions & Answers

• Question 111:

  You are at a customer site to perform a CLARiiON model conversion. Which utility would you have used to plan your course of action?

  A. CPG
  B. HEAT
  C. SWAT
  D. CAP
  A. CPG

• Question 112:

  A customer has heard that the maximum number of LUNs has changed on their model of CLARiiON with the introduction of the latest code. Which document will help them understand the implications of a code upgrade?

  A. FLARE Operating Environment Release Notes
  B. CLARiiON Best Practices for Fibre Channel Storage white paper
  C. CLARiiON Open Systems Configuration Guide
  D. CLARiiON Fibre Channel Storage Fundamentals white paper
  A. FLARE Operating Environment Release Notes

• Question 113:

  What is the purpose of the Element Size Multiplier in the Unisphere Expand Storage Wizard?

  A. Sets the stripe element size for a metaLUN component
  B. Specifies the relative importance of making additional LUN capacity available to the host
  C. Sets the exact element size of the private information on the LUN
  D. Enables or disables Auto-assign for the metaLUN you are creating
  A. Sets the stripe element size for a metaLUN component

• Question 114:

  Which initiator failover mode should be set in order to have a host interact with ALUA on the CLARiiON?

  A. 4
  B. 3
  C. 2
  D. 1
  A. 4

• Question 115:

  While installing a B-series DCX 48000 switch it is important to understand which ports use a specific ASIC. A single ASIC is responsible for how many ports in a DCX 48000 switch?

  A. 24
  B. 12
  C. 18
  D. 48
  A. 24

• Question 116:

  A customer would like to configure NTP using Unisphere. What is the minimum polling time allowed for NTP?

  A. 30 minutes
  B. 60 minutes
  C. 15 minutes
  D. 10 minutes
  A. 30 minutes

• Question 117:

  Security is a major concern for a customer who purchased a CX4, so they implemented LDAP authentication. During a LUN migration from LUN 6 to LUN 7 the following start command failed due to a wrong scope value.

  naviseccli migrate –start –source 6 –dest 7 –rate low –user myname –scope 3 –password mypass

  Which scope value should have been used?

  B. 1
  D. 4
  A

• Question 118:

  How many front-end ports are required to provide failover between SPs for eight direct-attached hosts on a CX4?

  A. 16
  B. 8
  C. 4
  D. 2
  A. 16

• Question 119:

  What communication protocol does Unisphere use?

  A. SSL
  B. SFTP
  C. UDP
  D. SSH
  A. SSL

• Question 120:

  A customer has finished configuring the zoning on their MDS switch. What would be the result of the following command? zoneset activate name ActiveZS vsan 100

  A. Activates the zoneset named ActiveZS on VSAN 100
  B. Creates the zoneset named ActiveZS on VSAN 100
  C. Creates and activates VSAN 100
  D. VSAN 100 is named ActiveZS
  A. Activates the zoneset named ActiveZS on VSAN 100