CWNP CWDP-305 Online Practice Questions and Exam Preparation

CWNP CWDP-305 Online Questions & Answers

• Question 201:

  What are methods of providing RF high availability?

  Response:

  A. Power APs to maximum power.
  B. Use the HSRP/VRRP protocol.
  C. Deploy using 100 percent overlap.
  D. Deploy 802.3af.
  E. Use dual spectrums.
  C. Deploy using 100 percent overlap.

• Question 202:

  Why does a frame transmitted at 1 Mbps have a greater usable range than the same frame transmitted at 54 Mbps?

  A. Free space path loss causes greater signal dispersion for higher rate transmissions.
  B. Receiver sensitivity requirements are lower for frames transmitted with less complex modulation and coding.
  C. To improve reliability, 802.11 STAs increase transmit power as the signaling rate decreases.
  D. Lower data rate RF transmissions travel at higher speeds and are less likely to experience collisions.
  B. Receiver sensitivity requirements are lower for frames transmitted with less complex modulation and coding.

• Question 203:

  What is the minimum PoE budget needed on a switch to support 6 (six) APs that can only be powered using IEEE 802.3at if no other details are provided?

  A. 320 W
  B. 60 W
  C. 180 W
  D. 240 W
  C. 180 W

• Question 204:

  An MSA commonly addresses at least which two legal categories? Response:

  A. Nondisclosure agreement
  B. Hold harmless
  C. Intellectual property protection
  D. Indemnity clause
  A. Nondisclosure agreement

• Question 205:

  As an implementation engineer, you have just received initial design specs from a network designer for your dual-band 802.11n deployment. The network design documents prescribe the following data rate configuration for the 2.4 GHz radio:

  Basic Rates 5.5, 6, 11, 12 Mbps

  Supported Rates 9, 18, 24, 36, 48, and 54 Mbps as well as MCS 0-15

  What will result from this design strategy?

  A. By disabling support for 1 and 2 Mbps while allowing 5.5 and 11 Mbps, the network will force 802.11b clients to use these higher data rates.
  B. Protection mechanisms will always be in use on this network to support 5.5 and 11 Mbps as basic rates.
  C. HR/DSSS (802.11b) stations will not be able to associate to the service set.
  D. This configuration violates the IEEE specification that defines 6, 12, and 24 Mbps as mandatory data rates for 802.11g/n.
  A. By disabling support for 1 and 2 Mbps while allowing 5.5 and 11 Mbps, the network will force 802.11b clients to use these higher data rates.

• Question 206:

  What are some significant drawbacks that are present with WPA/WPA2-Enterprise that are not present with WPA/WPA2-Personal?(Choose all that apply.) Response:

  A. WPA/WPA2-Enterprise does not support the use of usernames/passwords for client authentication.
  B. WPA/WPA2-Enterprise often requires additional backend infrastructure components that are not required with WPA/WPA2-Personal.
  C. WPA/WPA2-Enterprise often requires more administrative overhead for configuration than WPA/WPA2-Personal.
  D. WPA/WPA2-Enterprise always requires X.509 certificates for server authentication.
  E. WPA/WPA2-Enterprise does not provide a way to perform per-user authorization and access control.
  B. WPA/WPA2-Enterprise often requires additional backend infrastructure components that are not required with WPA/WPA2-Personal.
  C. WPA/WPA2-Enterprise often requires more administrative overhead for configuration than WPA/WPA2-Personal.

• Question 207:

  What is a typical characteristic of barcode scanners?

  A. Low throughput requirements
  B. High throughput requirements
  C. Implementation of 3x3 3 chipsets
  D. No support for any 802.11 security solutions
  A. Low throughput requirements

• Question 208:

  You are designing a WLAN and nave been asked to recommend a security solution for the network The organization requires that 802 1X/EAP be implemented, but they do not have a PKI and do not wish to deploy one They suggest that mostly Windows clients. Apple phones and Android phones will be used What do you recommend?

  A. Use CCMP AES with a PSK
  B. Use EAP-PEAP for the authentication solution
  C. Use FAP-TLS for the authentication solution
  D. Use TKIPRC4 with a PSK
  B. Use EAP-PEAP for the authentication solution

• Question 209:

  You are selecting external antennas for use in a bridge link deployment. What chart should you request from the antenna vendors to make an accurate selection?

  A. mW to dBm conversion chart
  B. dBm to dB conversion chart
  C. Elevation chart
  D. Antenna coating chart
  C. Elevation chart

• Question 210:

  Which of the following items could be considered constraints when performing a network design?(Choose all that apply.)

  Response:

  A. Timeline
  B. Personnel
  C. Politics
  D. Budget
  A. Timeline
  B. Personnel
  C. Politics
  D. Budget