CWNP CWDP-305 Online Practice Questions and Exam Preparation

CWNP CWDP-305 Online Questions & Answers

• Question 191:

  What action should be taken after implementing a WLAN based on the design developed from the site survey process?

  A. Post-installation survey
  B. Requirements analysis
  C. Gathering facility documentation
  D. Design the infrastructure services
  A. Post-installation survey

• Question 192:

  When deploying long-distance 802.11 bridge links (10 miles / 16 km), what parameter may be critical for improving data flow by reducing retries caused by the long distances?

  A. The sequence control field value
  B. The acknowledgement timeout threshold
  C. The minimum transmit data rate value
  D. The CTS-to-self threshold
  B. The acknowledgement timeout threshold

• Question 193:

  When designing a static channel plan for an office using voice devices near an airport, which range of channels may be avoided to avoid channel switching when implemented in this environment?

  A. 36-40
  B. 44-48
  C. 116-124
  D. 1-11
  C. 116-124

• Question 194:

  If the amplifier in Question 4 has a noise figure of 10 dB but a gain of 0 dB, what is the total noise figure of the cable, amplifier, and filter in series? Response:

  A. 75 dB
  B. 16 dB
  C. 10 dB
  D. 70 dB
  A. 75 dB

• Question 195:

  In a convention center auditorium, you've received complaints about the WLAN performance. Currently, only two APs are installed, but they are supporting over 300 client devices simultaneously, which exceeds the original design. What action should you take to ensure the Wi-Fi works as expected?

  A. Redesign the WLAN for the auditorium requirement area
  B. Quickly add more APs to the auditorium requirement area
  C. Upgrade the Ethernet connections to MultiGig
  D. Turn up the output power on the APs so that they can handle more clients
  A. Redesign the WLAN for the auditorium requirement area

• Question 196:

  You are preparing to perform a site survey for a company that processes meat, but some areas are restricted due to high security. What should you do in order to proceed with the site survey?

  A. Gain appropriate access and clearance to perform the site survey
  B. Gain meat processing access certification from the FDA
  C. Ensure that you and your team are using food industry approved USB adapters for the survey
  D. Just begin the survey, they will understand
  A. Gain appropriate access and clearance to perform the site survey

• Question 197:

  What operational plane would a WNMS primarily interact with? Response:

  A. Integration
  B. Management
  C. Control
  D. Data
  E. Distribution
  B. Management

• Question 198:

  Before performing a pre-deployment passive RF survey of a new deployment using survey mapping software, which of the following must be performed?

  A. Determining AP transmit power
  B. Scaling the map
  C. Selecting antennas
  D. Checking client DTPC settings
  B. Scaling the map

• Question 199:

  When viewing channel utilization information from a protocol analyzer, if high channel utilization is occurring, what should you ensure does not exist? Response:

  A. A high percentage of low PHY rates
  B. An RF signal generator causing an RF DoS
  C. High levels of workload
  D. High frames per second
  A. A high percentage of low PHY rates

• Question 200:

  During lunch time in the break room of a company, Wi-Fi connectivity on the 2.4 GHz band is intermittent. Every other time of the day, it works fine. What's the likely cause of this issue? Response:

  A. Employees are using their cell data instead of using the Wi-Fi
  B. The AP in the cafeteria keeps rebooting due to lack of PoE budget on the switch
  C. Microwaves in the cafeteria are interfering with the Wi-Fi on the 2.4 GHz band
  D. Toasters and ovens are heating up the air, raising the noise floor with the Wi-Fi on the 2.4 Ghz band
  C. Microwaves in the cafeteria are interfering with the Wi-Fi on the 2.4 GHz band