CWNP CWDP-305 Online Practice Questions and Exam Preparation

CWNP CWDP-305 Online Questions & Answers

• Question 121:

  Even when a full pre-design site survey is not performed, what is always recommended to be performed within the deployment areas?

  A. A spectrum analysis walkthrough
  B. An AP-on-a-stick survey of 37% of the facility as this amount provides all of the statistical information required for good design
  C. A scan m the 5 GHz band looking for common loT interferes
  D. A scan in the Sub-i GHz bands to determine If sideband interference will impact 2 4 GHz operations
  A. A spectrum analysis walkthrough

• Question 122:

  Given A project parameter defines a requirement or constraint (or a project that can be defined before any file imports or design actions. What is an example of a project parameter commonly available in WLAN design software?

  A. AP locations
  B. Minimum required signal strength
  C. AP type selection
  D. Floor plan
  B. Minimum required signal strength

• Question 123:

  Which document provided to your customer should include all devices and parts that are going to be used during the deployment of their WLAN infrastructure?

  A. SoW
  B. BoM
  C. Design report
  D. Project plan
  B. BoM

• Question 124:

  What part of the 802.11n preamble is used by the receiver to estimate the spatially multiplexed signal channel? What mode is this used in? Response:

  A. HT-STF in Greenfield mode only
  B. HT-LTF in Mixed and Greenfield modes
  C. HT-LTF in Greenfield mode only
  D. HT-STF in Mixed and Greenfield modes
  B. HT-LTF in Mixed and Greenfield modes

• Question 125:

  What is the most appropriate antenna which will require the least Intentional Radiator power for a point-to-point bridge link spanning 1200 meters?

  A. 2.2 dBi omnidirectional
  B. 11 dBi omnidirectional
  C. 11 dBi disn
  D. 5 dBi patch
  C. 11 dBi disn

• Question 126:

  To increase capacity in a coverage-based wireless network, which of the following techniques are typically recommended?(Choose all that apply.) Response:

  A. Maximize airtime usage by disabling lower data rates.
  B. Add additional APs and use directional antennas.
  C. Turn up power on the access points.
  D. Lower power on the access points and, after careful planning, add more AP
  A. Maximize airtime usage by disabling lower data rates.
  B. Add additional APs and use directional antennas.
  D. Lower power on the access points and, after careful planning, add more AP

• Question 127:

  When analyzing published competitive tests by equipment vendors, what items are the tests usually lacking?(Choose all that apply.) Response:

  A. Client devices and configurations
  B. Audit by a third party
  C. Detailed test methodology
  D. Detailed configurations of each vendor's equipment
  A. Client devices and configurations
  C. Detailed test methodology
  D. Detailed configurations of each vendor's equipment

• Question 128:

  What are the two most common industry-standard protocols used to transport data from an AP to a Wireless LAN Controller?

  A. CAPWAP and GRE
  B. LWAPP and FTP
  C. SSL and SSH
  D. TLS and SSL
  A. CAPWAP and GRE

• Question 129:

  Which document outlines the objectives, scope, and key stakeholders, serving as the official authorization to begin a WLAN design and deployment project?

  A. Bill of Materials
  B. Project Charter
  C. Work Breakdown Structure
  D. Budget
  B. Project Charter

• Question 130:

  What is the minimum PoE budget required to power 6 APs using IEEE 802.3at with no additional details provided?

  A. 320 W
  B. 60 W
  C. 180 W
  D. 240 W
  C. 180 W