ASVAB ASVAB-SECTION-4 Online Practice Questions and Exam Preparation

ASVAB ASVAB-SECTION-4 Online Questions & Answers

• Question 191:

  Which is considered the left side of an engine?

  A. The left side when you stand feeing the car in front.
  B. The side that the starter motor is on.
  C. Depends on the manufacturer.
  D. The left side when you sit in the driver's seat and face forward.
  D. The left side when you sit in the driver's seat and face forward.

• Question 192:

  A ripsaw cuts __________.

  A. against the grain of the wood
  B. with the grain of the wood
  C. most materials, including metal
  D. only plastic
  B. with the grain of the wood

• Question 193:

  What gear is the transmission in when the engine is driving the car directly?

  A. first gear
  B. second gear
  C. third gear
  D. fourth gear
  C. third gear

• Question 194:

  A two-cycle engine will normally be found on __________.

  A. small cars
  B. large diesel trucks
  C. trucks, vans, and some cars
  D. snowmobiles, chainsaws, and some motorcycles
  D. snowmobiles, chainsaws, and some motorcycles

• Question 195:

  The primary purpose of piston rings is to __________.

  A. seal the combustion chamber and allow the pistons to move freely.
  B. connect the piston to the crankshaft.
  C. allow fuel to enter the piston cylinder.
  D. provide lubrication to the piston cylinder.
  A. seal the combustion chamber and allow the pistons to move freely.

• Question 196:

  Which automotive system uses universal joints, a drive shaft, and a clutch?

  A. the transmission system
  B. the braking system
  C. the steering system
  D. the cooling system
  A. the transmission system

• Question 197:

  The gauge that measures the electrical charge in a car is called the ___________.

  A. speedometer
  B. pressure gauge
  C. ammeter
  D. tachometer
  C. ammeter

• Question 198:

  Nail sets are used to __________.

  A. protect your fingers from the hammer.
  B. set nails below the surface of wood.
  C. complete projects requiring sets of nails.
  D. mark the position where the nail should go.
  B. set nails below the surface of wood.

• Question 199:

  Machine screws __________.

  A. are made by machines
  B. can be used interchangeably with wood screws
  C. fasten metal parts
  D. are machined to fine tolerances
  C. fasten metal parts

• Question 200:

  To check for horizontal trueness, the best tool to use is a __________.

  A. steel tape rule
  B. plumb bob
  C. level
  D. sliding T-bevel
  C. level