Acme Packet AP0-001 Online Practice Questions and Exam Preparation

Acme Packet AP0-001 Online Questions & Answers

• Question 61:

  Which one of the following statements is TRUE when H245 tunneling is enabled on the Net-Net 4000. The Net-Net 4000 will________________.

  A. tunnel signaling messages over the H.245 connection
  B. establish a separate TCP connection to tunnel messages
  C. tunnel H.245 messages over H.225.0 FACILITY messages
  D. support the Generic Tunneling Protocol (GTP) for sending SIP messages over the 245 connection
  C. tunnel H.245 messages over H.225.0 FACILITY messages

• Question 62:

  Examine the H323 stack configuration below.

  

  Based on the information above, which one of the following IP addresses should be configured as a hip-ip-address in the appropriate network interface?

  A. 0.0.0.0
  B. 172.16.0.100
  C. 172.16.0.13
  D. 172.16.0.0
  C. 172.16.0.13

• Question 63:

  RRQ, ARQ, DRQ, and IRR are all examples of __________ signaling messages.

  A. H.225.0 RAS
  B. SIP
  C. MGCP
  D. H.245
  A. H.225.0 RAS

• Question 64:

  Steering pools are realm specific, and by limiting the number of __________ provide constraints on the number of concurrent RTP sessions allowed on the Net-Net 4000.

  A. UDP ports
  B. slots
  C. IP addresses
  D. Realms
  A. UDP ports

• Question 65:

  The __________ field indicates whether or not an H.323 stack runs as a gateway.

  A. isgatekeeper
  B. mode
  C. gw-identifier
  D. isgateway
  D. isgateway

• Question 66:

  If upon examination of two configuration files you notice that the version number of the permanently saved configuration differs from the version number of the running configuration, it means that __________.

  A. the saved configuration file has been edited, but the done command was not issued
  B. the saved configuration file has been copied from flash into SDRAM using the save- config command
  C. the saved configuration file has been saved into flash, but the activate-config command has not been issued
  D. the saved configuration file was copied from flash into SDRAM using the activate-config command
  C. the saved configuration file has been saved into flash, but the activate-config command has not been issued

• Question 67:

  When installing a Net-Net Operating System named sd400p9.gz on your Net-Net 4000, you should FTP the OS to the Net-Net 4000 internal bootWhen installing a Net-Net Operating System named sd400p9.gz on your Net-Net 4000, you should FTP the OS to the Net-Net 4000? internal boot flash memory and use which of the strings below in the file name field of the boot parameters?

  A. sd400p9.gz
  B. /tffs0/sd400p9.gz
  C. /boot/sd400p9
  D. /boot/sd400p9.gz
  B. /tffs0/sd400p9.gz

• Question 68:

  Which one of the following statements about SIP is FALSE?

  A. The Via header field indicates the transport used for the transaction.
  B. The Contact header field provides a SIP or SIPS URI that can be used to contact that specific instance of the UA for subsequent requests.
  C. A SIP transaction consists of a single request and any responses to that request, which include zero or more provisional responses and one or more final responses.
  D. A dialog is identified at each UA with a dialog ID, which consists of a Call-ID value, a Contact and a Request URI.
  D. A dialog is identified at each UA with a dialog ID, which consists of a Call-ID value, a Contact and a Request URI.

• Question 69:

  Which one of the following statements about SIP is FALSE?

  A. The Via header field indicates the transport used for the transaction.
  B. The Contact header field provides a SIP or SIPS URI that can be used to contact that specific instance of the UA for subsequent requests.
  C. A SIP transaction consists of a single request and any responses to that request, which include zero or more provisional responses and one or more final responses.
  D. A dialog is identified at each UA with a dialog ID, which consists of a Call-ID value, a Contact and a Request URI.
  D. A dialog is identified at each UA with a dialog ID, which consists of a Call-ID value, a Contact and a Request URI.

• Question 70:

  __________ are stored in NVRAM.

  A. Logs
  B. CDRs
  C. Boot parameters
  D. Backup configurations
  C. Boot parameters