ASQ CSSBB Online Practice Questions and Exam Preparation

ASQ CSSBB Online Questions & Answers

• Question 1:

  A Belt rearranged the location of the parts inventory for a rework station locating the most often used parts to be within hand reach of the repair person. This rearrangement resulted in quicker repair times by eliminating one of seven major elements of waste which is the Waste of __________.

  A. Motion
  B. Conveyance
  C. Inventory
  D. Waiting
  A. Motion

• Question 2:

  Which statement is NOT correct about the Fitted Line Plot shown here?

  

  A. The independent variable is the reactant
  B. If the reactant was 6 units, with 95 % confidence we would expect a minimum yield of 100 units
  C. With at least 95% confidence, we can expect less than 10 units of Yield when the reactant is at a value of 1
  D. A reactant value between 2 and 4 units yields around 20 to 40
  E. When the reactant increases, the expected yield would increase
  D. A reactant value between 2 and 4 units yields around 20 to 40

• Question 3:

  For a Kanban to be successful which of these must occur?

  A. Consistent cycle times
  B. Fairly stable process demand of product or service
  C. Low defect rate of incoming product or service
  D. All of the above
  D. All of the above

• Question 4:

  A Belt has determined that the inventory of repair parts at a rework station can be reduced by 45%. According to Cost of Poor Quality (COPQ) definitions inventory reduction would be considered _______________.

  A. Soft Savings
  B. COPQ efficiency
  C. Median Savings
  D. Hard Savings
  D. Hard Savings

• Question 5:

  A ___________ problem in the Measurement System suggests that there is a lack of consistency in the measurement over time.

  A. Linearity
  B. Bias
  C. Stability
  D. Magnitude
  C. Stability

• Question 6:

  Production Line 1 is able to complete 500 units per shift. Production Line 2 is able to finish 1,500 units per shift. Production Line 2 is 3 times faster than Production Line 1. This analysis is an example of ______________ Scale Data.

  A. Nominal
  B. Ratio
  C. Ordinal
  D. Interval
  B. Ratio

• Question 7:

  The most appropriate type of FMEA for a product before going into manufacturing is a ___________ FMEA.

  A. Design
  B. Consumer
  C. Survey
  D. Test Process
  A. Design

• Question 8:

  Control Charts were developed by Dr. Shewhart to track data over time. To detect Special Cause variation the Control Charts use which of these?

  A. Data shift analysis
  B. Outlier analysis methods
  C. Center Line and Control Limits
  D. None of the above
  C. Center Line and Control Limits

• Question 9:

  Each of the items listed would impact the Process Capability for a process with a continuous output except ___________________.

  A. Shape of process data distribution (e.g. Normal Distribution)
  B. Process Technology
  C. Process Standard Deviation
  D. Seasonal variation in process
  B. Process Technology

• Question 10:

  Statistical Difference is the magnitude of difference or change required to distinguish between a true difference, brought about by change or improvement, and one that could have occurred by chance.

  A. True
  B. False
  A. True