642-661 Exam Details

  • Exam Code
    :642-661
  • Exam Name
    :CCIP Configuring BGP on Cisco Routers (BGP)
  • Certification
    :Cisco Certifications
  • Vendor
    :Cisco
  • Total Questions
    :181 Q&As
  • Last Updated
    :Dec 15, 2021

Cisco 642-661 Online Questions & Answers

  • Question 41:

    What are two characteristics of BGP confederations? (Choose two.)

    A. All routers within the BGP confederation must support BGP confederations.
    B. An Intra-Confederation EBGP session behaves like an EBGP session when propagating routing updates.
    C. The member AS numbers used within the confederation are visible from outside the confederation.
    D. Intra-Confederation EBGP neighbors must be directly connected orebgp-multihop must be configured.

  • Question 42:

    omitted) ! router bgp 65500 neighbor 172.25.25.25 remote-as 65501 neighbor 172.22.22.25 remote-as 65502 neighbor 172.23.23.22 remote-as 65503 ! (output omitted)

    You work as a network technician. Study the exhibit carefully. Which of the following is the correct set of commands to establish a minimum routing update interval of 60 seconds for all neighbors?

    A. R-3(config-router)#neighbor advertisement-interval 60
    B. R-3(config-router)#neighbor 172.25.25.25 advertisement-interval 60 R-3(config-router)#neighbor 172.25.22.22 advertisement-interval 60 R-3(config-router)#neighbor 172.23.23.23 advertisement-interval 60
    C. R-3(config-router)#bgp neighbor advertisement-interval 60
    D. R-3(config-router)#timersbgp 60 60 60

  • Question 43:

    What state will a BGP session move to immediately after the router sends a BGP Open message to its neighbor?

    A. OpenConfirm
    B. OpenSent
    C. active
    D. idle
    E. established

  • Question 44:

    Router # show ip bgp 172.31.1.0

    BGP routing table entry for 172.31.1.0/24, version 15 Paths: (2 available, best #2, table Default-IF-Routing-Table)

    Advertised to non peer-group peers:

    10.1.0.2 10.200.200.3 10.200.200.4 172.31.11.1

    172.31.1.1 from 10.1.0.2 (10.200.200.2)

    Origin IGP, metric 0, localpref 100, valid, internal 65100

    172.31.1.1 from 172.31.1.1 (172.31.1.1)

    Origin IGP, metric 0, localpref 100, valid, external, best

    Based on the output shown in the exhibit, which two statements are correct? (Choose two)

    A. TheeBGP route to 172.31.1.0/24 is preferred over the iBGP route to 172.31.1.0/24.
    B. 172.31.1.1 is aniBGP peer.
    C. 10.1.0.2 is aniBGP peer.
    D. 10.200.200.3 is aneBGP peer.

  • Question 45:

    In the diagram, the customer is using BGP to connect to a single ISP over two permanent links. In this scenario, which input and output prefix-list filtering is typically enabled on the ISP routers? (Choose two.)

    A. ip prefix-list test-in permit 0.0.0.0/0
    B. ip prefix-list test-in permit 10.0.0.0/8 le 32
    C. ip prefix-list test-out permit 10.0.0.0/8 le 32
    D. ip prefix-list test-out permit 10.1.1.0/24 le 32
    E. ip prefix-list test-in permit 10.1.1.0/24 le 32
    F. ip prefix-list test-out permit 0.0.0.0/0

  • Question 46:

    In the user of hierarchical route reflector design, what is the maximum number of route reflectors that can be configured?

    A. 1
    B. 2
    C. 3
    D. no limit

  • Question 47:

    A Transit AS contains 10 routers. To enable full mesh IBGP within that Transit AS, how many IBGP sessions are required?

    A. 10
    B. 28
    C. 45
    D. 50

  • Question 48:

    Refer to the exhibit. Service provider A (AS 123) has an EBGP session to the customer where the AS number 65053 is used at the customer end. Service provider B (AS 234) also has an EBGP session to the customer where the AS number 65286 is used at the customer end. The customer decides to use AS 65053 internally. All router BGP configuration lines have 65053 as the AS number. The customer uses AS number 65286 only when establishing the EBGP session to AS

    234. In this case, which is the correct configuration?

    A. The neighbor {ip-address} local-as {private-as} command is needed on the customer router that is connected to Service Provider B.
    B. The neighbor {ip-address} local-as {private-as} command is needed on the Service Provider router in AS 123.
    C. The neighbor {ip-address} local-as {private-as} command is needed on the Service Provider router in AS 234.
    D. The neighbor {ip-address} local-as {private-as} command is needed on the customer router that is connected to Service Provider A.

  • Question 49:

    DRAG DROP

    Select and Place:

  • Question 50:

    Which Cisco IOS command is used to view the amount of CPU resources consumed (utilization) due to running BGP processes?

    A. show ipbgp process
    B. show memory | include BGP
    C. show processcpu | include BGP
    D. show ip protocols | include BGP

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 642-661 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.