Cisco 640-916 Online Practice Questions and Exam Preparation

Cisco 640-916 Online Questions & Answers

• Question 171:

  Which two options are two functions of the data center access layer? (Choose two.)

  A. high data transfer rate
  B. packet filtering
  C. server connections
  D. QoS policy enforcement
  E. high network fault tolerance
  F. VLAN creation
  C. server connections
  F. VLAN creation

• Question 172:

  

  {exhibit 1805}

  Refer to the exhibit. NP uplink ports connected to the core NPIV switch do not come online and are stuck in an initializing state. What is the cause that NP Uplink ports on NPV edge switch are stuck in initializing state?

  A. The upstream NP Ports and the downstream server F Ports on the NPV edge switch may not be in the same VSA.
  B. The core switch has not been enabled for NPIV.
  C. The upstream VSAN ports and the server ports are in full duplex mode.
  D. Related VSAN identifier is not allowed on Virtual Port Channels toward the edge switch.
  B. The core switch has not been enabled for NPIV.

• Question 173:

  What is the benefit of virtual contexts in ACE for server load balancing?

  A. acts as several virtual appliances within a physical appliance
  B. compresses the data communication on ACE platforms
  C. integrates ACE gear with ASA firewalls for extra security
  D. facilitates data communication encryption
  A. acts as several virtual appliances within a physical appliance

• Question 174:

  Which four Cisco Nexus 2000 Series Fabric Extenders support host port channels? (Choose four.)

  A. 2148T
  B. 2224T
  C. 2248T
  D. 2248TP
  E. 2232PP
  F. 2232TM
  C. 2248T
  D. 2248TP
  E. 2232PP
  F. 2232TM

• Question 175:

  An administrator has installed two Cisco VIC adapters. The administrator has also configured four virtual network interface cards and two virtual host bus adapters. Using this configuration, how many PCI bus addresses will be presented to the server operating system?

  B. 4
  C. 6
  D. 8
  C. 6

• Question 176:

  An engineer has been asked to configure the Nexus 1000v for a ESXi Cluster. What component of the Nexus 1000v needs to be installed on the hosts?

  A. VSG
  B. VEM
  C. vShield
  D. DVS
  B. VEM

• Question 177:

  Refer to the exhibit.

  

  A network engineer proposes to consolidate core and distribution layers into one layer. Which design approach is the engineer suggesting?

  A. small enterprise design profile
  B. collapsed core design
  C. 2-tier network design
  D. 3-tier network design
  B. collapsed core design

• Question 178:

  A company is considering unifying the data center fabrics. What two technologies will allow IP traffic and the Fibre Channel to run over the same fabric? (Choose two.)

  A. Rapid Spanning Tree
  B. Fibre Channel over Ethernet
  C. Overlay Transport Virtualization
  D. Data Center Bridging Exchange Protocol
  E. InfiniBand
  B. Fibre Channel over Ethernet
  D. Data Center Bridging Exchange Protocol

• Question 179:

  Which RAID level is associated with two dedicated parity drives?

  A. RAID 0
  B. RAID 1
  C. RAID 3
  D. RAID 4
  E. RAID 5
  F. RAID 6
  F. RAID 6

• Question 180:

  Refer to the exhibit.

  

  Which two pieces of configuration information about interface Ethernet 1/10 can the engineer determine? (Choose two.)

  A. It runs at 10 Gbps.
  B. It is part of a logical port channel interface.
  C. It is configured as a point-to-point interface.
  D. It is administratively down.
  E. It uses a nonstandard MTU size.
  A. It runs at 10 Gbps.
  B. It is part of a logical port channel interface.