Cisco 500-240 Online Practice Questions and Exam Preparation

Cisco 500-240 Online Questions & Answers

• Question 1:

  In a Unified MPLS for IP MBH context, what are pre-aggregation nodes?

  A. are route reflector clients of the Core Route reflector
  B. are route reflector clients of the core node ASBR
  C. are route reflector clients of the core node ABR
  D. are all route reflector
  C. are route reflector clients of the core node ABR

• Question 2:

  Which technology adopts a strategy in which the core, aggregation, and access networks are partitioned into separate MPLS/IP domains that are isolated at the IGP level but are still integrated through BGP labeled-unicast for the forwarding of unicast traffic?

  A. Unified MPLS
  B. SONET
  C. LDP
  D. LFA FRR
  A. Unified MPLS

• Question 3:

  What does SyncE mainly provides?

  A. SyncE provides for time of day synchronization
  B. SyncE provides for accurate frequency synchronization
  C. SyncE provides for phase synchronization
  D. SyncE provides for time of day
  B. SyncE provides for accurate frequency synchronization

• Question 4:

  Which three options can be considered a type of small cell (Choose three.)

  A. Microcell
  B. Femtocell
  C. Micro
  D. Pico
  E. Picocell
  F. Dendriticcell
  A. Microcell
  B. Femtocell
  E. Picocell

• Question 5:

  Which two options configures an ASR920 router as a hybrid clock? (Choose two.)

  A. ptp clock boundary domain 0
  B. ptp clock boundary domain 0 hybrid
  C. ptp clock ordinary domain 0 hybrid
  D. ptp clock ordinary domain 0
  E. ptp clock
  B. ptp clock boundary domain 0 hybrid
  C. ptp clock ordinary domain 0 hybrid

• Question 6:

  If a router receives routes from a route reflector, packets destined to the learned prefixes by default must go through what path?

  A. To the next BGP hop
  B. To the BGP neighbor
  C. The Route Reflextor
  D. To the Next IGP hop
  A. To the next BGP hop

• Question 7:

  What can PTP be used to synchronize?

  A. Time, frequency, phase
  B. Rate
  C. Phase, time
  D. Frequency
  A. Time, frequency, phase

• Question 8:

  What is frequency, phase, and time of day synchronization in mobile architecture?

  A. is natively supported in IPv6
  B. is a key requirement for the radio equipment
  C. is not important
  D. was only required for legacy
  B. is a key requirement for the radio equipment

• Question 9:

  What does the neighbor send label command enable when issued on BGP routers?

  A. Enables the routers to add IPv6 labels to outgoing BGP updates
  B. Enables an EBGP multihop peer to propagate the next hop unchanged
  C. Enables the routers to add MPLS labels to outgoing BGP updates
  D. Allows peering between loopbacks
  C. Enables the routers to add MPLS labels to outgoing BGP updates

• Question 10:

  DRAG DROP

  Match each device series on the left with its placement in a MBH network on the right. (Not all options will be used).

  Select and Place:

  

  ---