Cisco 500-210 Online Practice Questions and Exam Preparation

Cisco 500-210 Online Questions & Answers

• Question 21:

  During Automatic Node Setup, if cards are not already installed, what will the setup tool do during slot setup?

  A. abort the procedure and restart
  B. skip over the empty slots and proceed to the next step
  C. return an error message, disconnect, and restart
  D. preprovision the slots with the appropriate card
  D. preprovision the slots with the appropriate card

• Question 22:

  Which two options are the two modes of operation for the 10 port SFP+ line card? (Choose two.)

  A. 10 x 10G muxponder client for 100G line card
  B. wire speed encryption
  C. 5 x 10G transponder
  D. dispersion compensation
  A. 10 x 10G muxponder client for 100G line card
  C. 5 x 10G transponder

• Question 23:

  In which type of configuration are the MD-48 add/drop modules unusable?

  A. colorless
  B. omnidirectional
  C. 2-degree
  D. multidegree
  A. colorless

• Question 24:

  What does the Functional View show in Cisco Transport Controller?

  A. power levels of each wavelength
  B. slot assignments of line cards in the chassis
  C. fiber interconnections between cards and nodes
  D. wavelength routing through the network
  C. fiber interconnections between cards and nodes

• Question 25:

  The 10G Wire Speed Encryption line card encrypts the payload of which protocol?

  A. Ethernet
  B. OTN
  C. IP
  D. SONET/SDH
  B. OTN

• Question 26:

  Which file is exported by Cisco Transport Planner and is used to provision nodes during installation?

  A. Bill of Materials
  B. NE Update
  C. Circuit Report
  D. Internal Connections
  B. NE Update

• Question 27:

  Which feature enables the output Cisco Transport Planner to directly provision an NCS 2000 network element?

  A. easy setup
  B. automatic node setup
  C. software defined networking
  D. autoprovisioning
  B. automatic node setup

• Question 28:

  In a mesh ROADM node, how many degrees is an omnidirectional add/drop unit accessible from?

  A. 1 degree
  B. 4 degrees
  C. 16 degrees
  D. all degrees
  E. multidegrees
  D. all degrees

• Question 29:

  Which option describes the purpose of the USB ports on the external connection unit of the NCS 2006?

  A. to charge a USB powered device
  B. load software via a thumb drive
  C. inventory and monitoring of passive optical devices
  D. multishelf management
  C. inventory and monitoring of passive optical devices

• Question 30:

  Which technology allows 100G transponders to accept multiple wavelengths at their input, without requiring demultiplexing of the composite signal?

  A. QPSK modulation
  B. forward error correction
  C. coherent reception
  D. dual polarization modulation
  C. coherent reception