Cisco 500-171 Online Practice Questions and Exam Preparation

Cisco 500-171 Online Questions & Answers

• Question 1:

  Which statement is true for Fibre Channel QoS System Class?

  A. One can modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will be remarked to 0
  B. One cannot modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will be remarked to 0
  C. One can modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will not be remarked
  D. One cannot modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will not be remarked
  B. One cannot modify no-drop policy, and non FCoE traffic using natively the same class as FCoE will be remarked to 0

• Question 2:

  Which aggregates should be disabled for data aggregates?

  A. Snapshot copies
  B. SnapMirror copies
  C. FCP
  D. iSCSI
  A. Snapshot copies

• Question 3:

  NetApp recommends that your SSL key length be?

  A. 512
  B. 768
  C. 1024
  D. 9216
  C. 1024

• Question 4:

  Which two are two possible features of the `Call Home' feature in UCS Manager?

  A. Generates a text message to configured cell phone numbers
  B. Generates a syslog event
  C. Ability to proactively open a case with the Cisco TAC with the `Smart Call Home' feature
  D. Generates emails to predefined email addresses when a problem is detected
  E. Allows UCS to proactively pull down new software updates from Cisco
  C. Ability to proactively open a case with the Cisco TAC with the `Smart Call Home' feature
  D. Generates emails to predefined email addresses when a problem is detected

• Question 5:

  Refer to the exhibit.

  

  What management tool may be used for creating virtual machines?

  A. MMC
  B. System Center Virtual Machine Manager
  C. Hyper-V Manager
  D. System Center Orchestrator
  C. Hyper-V Manager

• Question 6:

  For a `boot from SAN' configuration, which two features must be enabled? (Choose two)

  A. FCOE
  B. UDLD
  C. NPIV
  D. FC
  E. FCSP
  F. VPC
  A. FCOE
  C. NPIV

• Question 7:

  Your primary VSM needs to be edited, rebooted, or migrated. You need to initiate a manual switchover to your standby VSM. What command will allow this to occur?

  A. vsm switchover
  B. System switchover
  C. Standby activate
  D. System standby
  B. System switchover

• Question 8:

  Refer to the exhibit.

  

  Which is correct for configuring FCoE?

  A. vlan 33fcoe vsan 43int po11switchport trunk allowed vlan add 33int vfc11bind interface po11switchport trunk allowed vsan 43vsan databasevsan 43 interface vfc11
  B. vlan 33fcoe vsan 43int po21switchport trunk allowed vsan add 43int vfc11bind interface po21vsan databasevsan 43 interface vfc 11
  C. fcoe vsan 43int po11switchport trunk allowed vsan add 43vsan databasevsan 43
  D. fcoe vlan 33int po11switchport trunk allowed vlan add 33vsan databasevsan 33
  E. fcoe vsan 43int po21switchport trunk allowed vsan add 43vsan databasevsan 43
  A. vlan 33fcoe vsan 43int po11switchport trunk allowed vlan add 33int vfc11bind interface po11switchport trunk allowed vsan 43vsan databasevsan 43 interface vfc11

• Question 9:

  To install your VEM, what is the extension of the VEM file name you'll be looking for to complete this install?

  A. .zip
  B. .vem
  C. .vib
  D. .vsm
  C. .vib

• Question 10:

  How many ACTIVE SPAN sessions exist on a Fabric Interconnect?

  A. 1
  B. 2
  C. 4
  D. 8
  E. 16
  B. 2