Nokia 4A0-C01 Online Practice Questions and Exam Preparation

Nokia 4A0-C01 Online Questions & Answers

• Question 781:

  Which of the following cannot be used as a matching criterion in route policy statements?

  A. Source IP address
  B. TCP source port
  C. Prefix list
  D. Protocol type
  D. Protocol type

• Question 782:

  In OSPFv3, which of the following LSA types carries prefixes and is only flooded in the area where it is generated?

  A. Link
  B. AS External
  C. Router
  D. Intra-Area Prefix
  D. Intra-Area Prefix

• Question 783:

  Which of the following statements are TRUE about configuring a distributed Epipe service? (Choose 2)

  A. The vc-id on the spoke-sdp must be explicitly configured.
  B. The vc-id on the mesh-sdp must be explicitly configured.
  C. The vc-id on the spoke-sdp can be configured to match the service id.
  D. The vc-id on the mesh-sdp can be configured to match the service id.
  E. The vc-id on the spoke-sdp does not have to be explicitly configured and will use the service id.
  F. The vc-id on the mesh-sdp does not have to be explicitly configured and will use the service id.
  A. The vc-id on the spoke-sdp must be explicitly configured.
  C. The vc-id on the spoke-sdp can be configured to match the service id.

• Question 784:

  Click on the exhibit.

  

  Given the output shown, which router is the ASBR in this network?

  A. 10.10.10.2
  B. 10.10.10.3
  C. 10.10.10.4
  D. 10.10.10.6
  E. There is no ASBR configured in the network.
  E. There is no ASBR configured in the network.

• Question 785:

  On a dot1Q encapsulated port, frames with a VLAN tag of 0 and untagged frames are forwarded to the null SAP

  A. TRUE
  B. FALSE
  A. TRUE

• Question 786:

  What best describes the type of packets used by OSPF routers to exchange updates on a pointto-point link?

  A. IP packets sent to an IP multicast address.
  B. Ethernet frames sent to an Ethernet multicast address.
  C. IP packets sent to an IP unicast address.
  D. UDP packets sent to an IP multicast address.
  A. IP packets sent to an IP multicast address.

• Question 787:

  If routers R1 and R2 have a Level 1 and Level 2 IS-IS adjacency, which of the following statements is true? Choose two answers.

  A. Routers R1 and R2 are in different areas.
  B. Routers R1 and R2 are in the same area.
  C. Routers R1 and R2 will send a Level 1 Hello PDU and Level 2 Hello PDU, if the interface type between them is point-to-point.
  D. Routers R1 and R2 will send a Level 1 Hello PDU and Level 2 Hello PDU, if the interface type between them is broadcast.
  E. Routers R1 and R2 will send a Level 1/2 Hello PDU if the interface type between them is broadcast.
  B. Routers R1 and R2 are in the same area.
  D. Routers R1 and R2 will send a Level 1 Hello PDU and Level 2 Hello PDU, if the interface type between them is broadcast.

• Question 788:

  Click on the exhibit.

  

  Based on the topology shown and the route tables of routers R3 and R4, which of the following is correct?

  A. There is no route leaking configured on router R1 or router R2.
  B. Route leaking is configured on router R1 but not on router R2.
  C. Route leaking is configured on router R2 but not on router R1.
  D. Route leaking is configured on both router R1 and router R2.
  D. Route leaking is configured on both router R1 and router R2.

• Question 789:

  What command syntax would be used to create a new IES service with a service id of 5 and a customer id of 1000?

  A. configure ies 5 customer 1000 create
  B. configure router ies 5 customer 1000 create
  C. configure service ies 5 customer 1000 create
  D. configure router ies 5 customer 1000
  C. configure service ies 5 customer 1000 create

• Question 790:

  Which MPLS label mode propagates a label mapping only for the FEC for which a router has a label mapping for the FEC's next-hop?

  A. Independent control mode
  B. Ordered control mode
  C. Liberal label retention mode
  D. Conservative label retention mode
  E. Downstream on demand label distribution mode
  B. Ordered control mode