Cisco 400-201 Online Practice Questions and Exam Preparation

Cisco 400-201 Online Questions & Answers

• Question 21:

  Which layer distinguishes the two types of the 10 Gigabit Ethernet technologies: LAN PHY and WAN PHY?

  A. Medium
  B. Physical Medium Attachment Sublayer
  C. Physical Medium Dependent Sublayer
  D. WAN Interface Sublayer
  D. WAN Interface Sublayer

• Question 22:

  Your IT company has been tasked to automate their view of the environment. The CTO has instructed you to use Ansible to focus on value-added tasks. Which four integrations do you use to achieve this outcome? (Choose four.)

  A. networks
  B. infrastructure
  C. Kubernetes
  D. management applications
  E. virtualization
  F. containers
  G. DevOps tools
  A. networks
  B. infrastructure
  F. containers
  G. DevOps tools

• Question 23:

  What is the main goal of the incident management?

  A. Restore a normal service operation as quickly as possible
  B. Create possible workarounds for issues that might recur
  C. Enable the cursor to report issues
  D. Ensure that the same incident does not recur
  A. Restore a normal service operation as quickly as possible

• Question 24:

  

  Refer to the exhibit. Test Inc. is troubleshooting a routing issue from the LAC to the inside network. Which solution should you configure on the LNS to correct the issue?

  A. The LAC and DMZ facing interfaces cannot be on the same physical interface
  B. The vrf forwarding DMZ command is required on interface Virtual-Template 1
  C. ip tcp adjust-mss on interface Virtual-Template 2 should be set to 1360.
  D. The vrf forwarding DMZ command is required on interface Gi0/1.100
  D. The vrf forwarding DMZ command is required on interface Gi0/1.100

• Question 25:

  

  Refer to the exhibit. A network engineer from ISP 2 is designing the BGP architecture with a requirement of preventing their customer AS 65001 from becoming a transit AS, using the following configuration. Router BGP 65000 Neighbor 10.0.0.1 remote-as 65001 Neighbor 10.0.0.1 route-map BGP-ROUTE-policy in Which Cisco IOS command should be used within the route-map to achieve the goal on ISP 2 from AS 65000?

  A. route-map BGP-ROUTE-POLICY permit 10 set community no-advertise additive
  B. ip as-path access-lists 1 permit^65001$ ! route-map BGP-ROUTE-POLICY deny 10 match as-path 1 ! route-map BGP-ROUTE-POLICY permit 10
  C. ip as-path access-list 1 permit^65001$ ! route-map BGP-ROUTE-POLICY permit 10 match as-path 1
  D. route-map BGP-ROUTE-POLICY permit 10 set community no-export additive
  C. ip as-path access-list 1 permit^65001$ ! route-map BGP-ROUTE-POLICY permit 10 match as-path 1

• Question 26:

  Drag and drop the IS-IS prefix type on the left onto the correct order from the most preferable(top) to the least preferable (bottom)

  Select and Place:

  

  

• Question 27:

  Which two components are shared across secure domain routers? (Choose two)

  A. Fabric
  B. CPU
  C. Memory
  D. Fans
  E. Forwarding engine
  A. Fabric
  D. Fans

• Question 28:

  

  Refer to the exhibit. CE6 cannot ping the loopback address of C7.An SP engineer notices a routing loop between PE2 and CE4. Which configuration must be applied on both PE routers to avoid the routing loop?

  A. Neighborsoo with the same SoO value on both PEs
  B. Neighborsoo with a different SoO value in each PE
  C. No neighbor as-override
  D. Neighbor allows-in
  A. Neighborsoo with the same SoO value on both PEs

• Question 29:

  Refer to the exhibit.

  

  Which BGP feature causes the BGP RIB entry "inaccessible"?

  A. BGP synchronization
  B. eBGP multihop
  C. BGP scanner
  D. BGP NHT
  D. BGP NHT

• Question 30:

  A service provider is using QoS to manage customer traffic over the MPLS backbone. Which three statements about the behavior of each MPLS QoS mode based on QoS policy in the service provider core are true? (Choose three.)

  A. Uniform mode does not change the original CE IP packet markings.
  B. Uniform mode changes the original CE IP packet markings.
  C. Pipe mode does not change the original CE IP packet markings.
  D. Pipe mode changes the original CE IP packet markings.
  E. Short-pipe mode does not change the original CE IP packet markings.
  F. Short-pipe mode changes the original CE IP packet markings.
  B. Uniform mode changes the original CE IP packet markings.
  C. Pipe mode does not change the original CE IP packet markings.
  E. Short-pipe mode does not change the original CE IP packet markings.