3V0-42.20 Exam Details

  • Exam Code
    :3V0-42.20
  • Exam Name
    :Advanced Design VMware NSX-T Data Center
  • Certification
    :VMware Certifications
  • Vendor
    :VMware
  • Total Questions
    :57 Q&As
  • Last Updated
    :May 28, 2026

VMware 3V0-42.20 Online Questions & Answers

  • Question 21:

    An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.

    This information was gathered by the architect during the Discover Task of the Engagement Lifecycle:

    Existing hardware will be used in any design proposal.

    Network bandwidth cannot be expanded.

    Which concept of the Discover Task do these items belong to? (Choose the best answer.)

    A. constraint
    B. requirement
    C. risk
    D. assumption

  • Question 22:

    An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

    This information was gathered during the Assessment Phase:

    NSX-T will span across two sites for disaster recovery.

    Public Load Balancer VIP should be accessible from a secondary site.

    Distributed Firewall Policies should be available at a secondary site.

    Routing capabilities should be maintained after failure.

    NAT capabilities are required.

    Which two selections should the architect include in their design? (Choose two.)

    A. Use of the same ISPs across sites.
    B. Use two separate ISPs across sites.
    C. Use MTU to 1550 between sites.
    D. Set MTU to 1550 between sites.
    E. Use IP sets or groups to configure DFW rules.

  • Question 23:

    An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution. Which risk is documented by an architect? (Choose the best answer.)

    A. The security team has a firewall communication matrix documented.
    B. The team is not trained for NSX-T but have a very strong experience with vSphere.
    C. Open communication between different application tiers is not allowed.
    D. Aggregate N-S throughput at any given time should be at least 10G.

  • Question 24:

    An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.

    This information was gathered by the architect during the Discover Task of the Enagagement Lifecycle:

    There are applications which use IPv6 addressing.

    Network administrators are not familiar with NSX-T Data Center solutions.

    Hosts can only be configured with two physical NICs.

    There is an existing management cluster to deploy the NSX-T components. Dynamic routing should be configured between the physical and virtual network. There is a storage array available to deploy NSX-T components.

    Which constraint was documented by the architect? (Choose the best answer.)

    A. Dynamic routing should be configured between the physical and virtual network.
    B. There are applications which use IPv6 addressing.
    C. Hosts can only be configured with two physical NICs.
    D. There are enough CPU and memory resources in the existing management cluster.

  • Question 25:

    A Solution Architect will be deploying an Ethernet Virtual Private Network (EVPN) in their NSX-T Data Center environment. What two selections must be prepared for the EVPN deployment? (Choose two.)

    A. deployed Tier-0 gateway
    B. deployed Load Balancer
    C. deployed Tier-1 gateway
    D. remote gateway with support for IGP and VLAN priority
    E. remote gateway with support for MP-BGP and VXLAN

  • Question 26:

    An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

    This information was gathered during the Assessment Phase:

    Customer currently has a single 10 host vSphere cluster.

    Customer wants to improve network security and automation.

    Current cluster utilization and business policies prevent changing the existing vSphere deployment.

    High-availability is important to the customer.

    Which three selections should the architect include in their design? (Choose three.)

    A. Apply vSphere DRS VM-Host anti-affinity rules to the virtual machines of the NSX-T Edge cluster.
    B. Deploy at least two NSX-T Edge virtual machines in the vSphere cluster.
    C. Deploy the NSX Controllers in the management cluster.
    D. Apply vSphere Distributed Resource Scheduler (vSphere DRS) VM-Host anti-affinity rules to NSX Managers.
    E. Remove 2 hosts from the cluster and create a new edge cluster.
    F. Remove vSphere DRS VM-Host affinity rules to the NSX-T Controller VMs.

  • Question 27:

    An administrator is asked to improve Recovery Point Objective (RPO) and Recovery Time Objective (RTO) for Disaster Recovery (DR) in their company network. The network has a primary site and a secondary site. The ability to support outages with minimum loss of connectivity to the company's core application is a priority.

    Which design should the administrator recommend? (Choose the best answer.)

    A. NSX-T Data Center using an Orchestrator to recover VMs across sites.
    B. NSX-T Data Center using Federation and dependencies set between primary and secondary sites.
    C. NSX-T Data Center using a registered third-party DR solution.
    D. NSX-T Data Center using built-in standard automation DR and secondary site recovery setup.

  • Question 28:

    A customer wants to use ECMP to provide additional throughput and availability for their critical business applications. Some applications require load balancing for scale and availability. Which two Edge design choices can an architect present to the customer? (Choose two.)

    A. Create a Tier-0 gateway in Active/Standby mode and a Tier-1 gateway in Active/Standby mode.
    B. Configure ECMP and Load Balancing on the Tier-0 gateway.
    C. Create a Tier-0 gateway in Active/Active mode and a Tier-1 gateway in Active/Standby mode.
    D. Create a Tier-0 gateway in Active/Standby mode.
    E. Configure ECMP on the Tier-0 gateway and Load Balancing on the Tier-1 gateway.

  • Question 29:

    An NSX-T architect is working with a customer who wants to improve performance and future-proof their workloads with a multi-site architecture.

    A current-state analysis captured this information:

    Latency between sites is 160ms.

    Bandwidth is 2Gbps.

    The MTU is 1600.

    What two VMware design recommendations should the architect recommend to the organization to achieve future-proofing? (Choose two.)

    A. MTU is recommended to be 9000.
    B. MTU must be at least 1700.
    C. Bandwidth must be at least 10Gbps.
    D. Latency RTT is acceptable.
    E. Latency must be less than 150ms.

  • Question 30:

    A telecom company has purchased NSX-T as part of a Software Defined Data Center (SDDC) initiative. The company wants to ensure the highest performance for network traffic leaving the virtual environment. Which two selections would an architect recommend to achieve the customer's goal? (Choose two.)

    A. Configure Equal-Cost Multi-Pathing on the NSX Edges.
    B. Configure SR-IOV for the virtual NSX Edges.
    C. Use bare metal NSX Edges.
    D. Select Network cards that support VXLAN Offload.
    E. Set "Latency Sensitive" option to High when deploying the virtual NSX Edges.

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only VMware exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 3V0-42.20 exam preparations and VMware certification application, do not hesitate to visit our Vcedump.com to find your solutions here.