350-050 Exam Details

  • Exam Code
    :350-050
  • Exam Name
    :CCIE Wireless Written
  • Certification
    :Cisco Certifications
  • Vendor
    :Cisco
  • Total Questions
    :320 Q&As
  • Last Updated
    :Dec 10, 2021

Cisco 350-050 Online Questions & Answers

  • Question 221:

    Refer to the exhibit.

    The IT manager is monitoring the wireless coverage of a floor. The manager sees the floor view that is shown. Which identifying information is displayed for the APs on the map view?

    A. Tx power level
    B. utilization
    C. profiles
    D. average air quality
    E. associated clients
    F. coverage hole

  • Question 222:

    You are converting your wireless infrastructure from a data-only design to a location services design. Which task do you need to complete?

    A. Disable the DSSS speeds for RFID compatibility.
    B. Use fewer APs to avoid RFID 3D imaging.
    C. Set APs to maximum power for RF fingerprinting.
    D. Locate APs at the edges of your coverage area for trilateration.

  • Question 223:

    A network administrator changed some wireless network SSID configuration settings on an autonomous AP. As a result, old clients can still connect by using the saved configuration on their wireless networks; however, new clients are not able to view or connect to the SSID.

    What is most likely the cause of the problem?

    A. The network administrator configured the SSID to not accept any new clients.
    B. The network administrator removed the broadcast command from the SSID configuration.
    C. The network administrator removed the guest-mode command from the SSID configuration.
    D. The network administrator changed the encryption algorithm of the SSID.

  • Question 224:

    Refer to the exhibit.

    This setup uses two Cisco APs as wireless bridges. One bridge is configured for root bridge mode and the other is configured for non-root bridge mode. Client A associates with the root bridge and Client B associates with the non-root bridge. Which three statements are true? (Choose three.)

    A. Two bridges that are in root mode can talk to each other.
    B. Only one device can connect to the ethernet connection of the non-root bridge.
    C. For two bridges to communicate with each other, one bridge should be in root mode and the other must be in non-root mode.
    D. The default setting of a bridge is root.
    E. Two bridges that are in root mode cannot talk to each other.
    F. The default setting of a bridge is non-root.

  • Question 225:

    Which three statements about the Cisco WCS auto-provisioning feature are true? (Choose three.)

    A. Auto-provisioning allows WCS to automatically configure a new or replace a current wireless LAN controller.
    B. The service port of the WLAN controller is required to have network connectivity for the auto-provisioning process to begin.
    C. DHCP Option 43 (vendor-specific information) has to be configured in the DHCP scope options for the auto-provisioning process to begin.
    D. DHCP Option 150 (TFTP server address) has to be configured in the DHCP scope options for the auto-provisioning process to begin.
    E. Using the add filter command in WCS will create a controller configuration file.
    F. WCS auto-provisions the management interface of the WLAN controller by pushing a predefined template.

  • Question 226:

    What is the minimum CCX version to support WMM?

    A. v2, which also supports Cisco Centralized Key Management
    B. v3, which also supports EAP-FAST
    C. v4, which also supports UPSD
    D. v5, which also supports MFP

  • Question 227:

    After performing a wireless site survey, you determine that to achieve proper HR-DSSS coverage within the rooms along a hallway area, the AP radios that service the hallway must be at 12 mW or higher. After the APs are all installed, you note that RRM is decreasing the power on the AP radios in the hallway to 6 mW. Which two methods can you use to prevent the HRDSSS AP radio power levels from dropping below 12 mW? (Choose two.)

    A. Configure the minimum power-level assignment for the 2.4 GHz radio to 11 dBm under the individual TPC settings on the hallway APs.
    B. Configure the minimum power-level assignment for the 5 GHz radio to 11 dBm under the individual TPC settings on the hallway APs.
    C. Configure the minimum power-level assignment to 11 dBm under the global 802.11b/g/n TPC settings.
    D. Configure the minimum power-level assignment to 11 dBm under the global 802.11a/n TPC settings.
    E. Statically configure the 5 GHz radios on the hallway APs to power level 4.
    F. Statically configure the 2.4 GHz radios on the hallway APs to power level 4.

  • Question 228:

    Which two statements about deploying high availability for the Cisco WCS are true? (Choose two.)

    A. The high availability license file needs to be installed on the primary WCS server.
    B. The secondary WCS needs to be installed with the same version as the primary WCS.
    C. The primary and secondary WCS servers are not required to share the same subnet.
    D. The primary and secondary WCS servers need to be set up as high availability pairs.

  • Question 229:

    Refer to the exhibit.

    According to the Cisco WCS floor map, which statement is true?

    A. All APs are affected by interference from Bluetooth.
    B. All APs are affected by interference from a video camera.
    C. Only AP1 is affected by interference from a video camera.
    D. Any device that uses channel 1 is affected by interference from a video camera.

  • Question 230:

    DRAG DROP

    Select and Place:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 350-050 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.