1. Home
  2. Cisco
  3. 300-410

Cisco 300-410 Online Practice Questions and Exam Preparation

300-410 Exam Details

  • Exam Code
    :300-410
  • Exam Name
    :Implementing Cisco Enterprise Advanced Routing and Services (ENARSI)
  • Certification
    :CCNP Enterprise
  • Vendor
    :Cisco
  • Total Questions
    :955 Q&As
  • Last Updated
    :May 25, 2026

Cisco 300-410 Online Questions & Answers

  • Question 301:

    Refer to the exhibit. An engineer is troubleshooting a TACACS problem. Which action resolves the issue?

    A. Configure a matching TACACS server IP.
    B. Configure a matching preshared key.
    C. Generate authentication from a relative source interface.
    D. Apply a configured AAA profile to the VTY.

  • Question 302:

    Refer to the exhibit. In an attempt to increase the network security, the administrator applied the Gi3-in ACL to the Gi3 interface. After the ACL was applied, clients in the network connected to Gi3 lost their ability to obtain IP settings from DHCP.

    Which two configuration commands must be added to the Gi3-in ACL to reinstate the DHCP service for the clients? (Choose two.)

    A. 74 permit udp 192.168.30.0 0.0.0.255 eq bootpc host 192.168.255.3 eq bootps
    B. 71 permit udp host 0.0.0.0 eq bootps host 255.255.255.255 eq bootpc
    C. 73 permit udp host 0.0.0.0 eq bootpc host 192.168.255.3 eq bootps
    D. 72 permit udp host 192.168.255.3 eq bootps 192.168.30.0 0.0.0.255 eq bootpc
    E. 75 permit udp host 0.0.0.0 eq bootpc host 255.255.255.255 eq bootps

  • Question 303:

    A newly installed spoke router is configured for DMVPN with the ip mtu 1400 command. Which configuration allows the spoke to use fragmentation with the maximum negotiated TCP MTU over GRE?

    A. ip tcp adjust-mss 1360 crypto ipsec fragmentation after-encryption
    B. ip tcp adjust-mss 1360 crypto ipsec fragmentation mtu-discovery
    C. ip tcp payload-mtu 1360 crypto ipsec fragmentation mtu-discovery
    D. ip tcp payload-mtu 1360 crypto ipsec fragmentation after-encryption

  • Question 304:

    Refer to the exhibit.

    An administrator configured a Cisco router for TACACS authentication, but the router is using the local enable password instead. Which action resolves the issue?

    A. Configure the aaa authentication login default group admin local if-authenticated command instead.
    B. Configure the aaa authentication login admin group tacacs+ local enable none command instead.
    C. Configure the aaa authentication login admin group tacacs+ local if-authenticated command instead.
    D. Configure the aaa authentication login admin group admin local enable command instead.

  • Question 305:

    DRAG DROP

    Drag and drop the actions from the left into the correct order on the right to configure a policy to avoid following packet forwarding based on the normal routing path.

    Select and Place:

  • Question 306:

    Refer to the exhibit.

    A network administrator configured name resolution for IPv6 traffic to be allowed through an inbound access list. After the access list is applied to resolve the issue, name resolution still did not work. Which action does the network administrator take to resolve the name resolution problem?

    A. Add permit udp any eq domain 53 any log in the access list
    B. Remove ipv6 inspect ipv6-firewall in from interface gi0/1
    C. Add permit udp any eq domain any log in the access list
    D. Inspect ipv6 inspect name ipv6-firewall udp 53 in global config

  • Question 307:

    How is a preshared key "Test" for all the remote VPN routers configured in a DMVPN using GRE over IPsec set up?

    A. authentication pre-share Test address 0.0.0.0 0.0.0.0
    B. set pre-share Test address 0.0.0.0 0.0.0.0
    C. crypto ipsec key Test address 0.0.0.0 0.0.0.0
    D. crypto isakmp key Test address 0.0.0.0 0.0.0.0

  • Question 308:

    Which mechanism provides traffic segmentation within a DMVPN network?

    A. BGP
    B. IPsec
    C. MPLS
    D. RSVP

  • Question 309:

    Which component of MPLS VPNs is used to extend the IP address so that an engineer is able to identify to which VPN it belongs?

    A. VPNv4 address family
    B. RD
    C. RT
    D. LDP

  • Question 310:

    Refer to the exhibit.

    An engineer is monitoring reachability of the configured default routes to ISP1 and ISP2. The default route from ISP1 is preferred if available. How is this issue resolved?

    A. Use the icmp-echo command to track both default routes
    B. Use the same AD for both default routes
    C. Start IP SLA by matching numbers for track and ip sla commands
    D. Start IP SLA by defining frequency and scheduling it

Related Exams:

Tips on How to Prepare for the Exams

Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only Cisco exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your 300-410 exam preparations and Cisco certification application, do not hesitate to visit our Vcedump.com to find your solutions here.