Cisco 300-365 Online Practice Questions and Exam Preparation

Cisco 300-365 Online Questions & Answers

• Question 1:

  SIMULATION

  Scenario

  One of your colleagues has setup a test network in the lab to simulate a new building atone of your regional offices. Your team is testing AP failover. Your colleague has requested you to configure the WLCs so that in the event of a loss of one

  of the WLCsthe other wings APs will fail over to the remaining WLC.

  The APs on the East-WLC-2504A should fail over to the West-WLC2-2504A, and the APs on the West-WLC2-2504A should fail over to the East-WLC-2504.

  Set the priority of the APs so the backup controller recognizes the join request from the higher-priority AP and if necessary disassociates a lower-priority AP to provide access to an available port.

  Not all menus, tabs and features are supported.

  Topology

  

  

  A. pending the answer
  A. pending the answer

• Question 2:

  Refer to the exhibit.

  

  Tunnel-Private-Group-Id(81): 15 Tunnel-Medium-Type(65): IEEE-802(6) Tunnel-Type(64): VLAN(13)

  A wireless client is connecting to FlexAP1 which is currently working standalone mode. The AAA authentication process is returning the following AVPs:

  Which three behaviors will the client experience? (Choose three.)

  A. While the AP is in standalone mode, the client will be placed in VLAN 15.
  B. While the AP is in standalone mode, the client will be placed in VLAN 10.
  C. When the AP transitions to connected mode, the client will be de-authenticated.
  D. While the AP is in standalone mode, the client will be placed in VLAN 13.
  E. When the AP is in connected mode, the client will be placed in VLAN 13.
  F. When the AP transitions to connected mode, the client will remain associated.
  G. When the AP is in connected mode, the client will be placed in VLAN 15.
  H. When the AP is in connected mode, the client will be placed in VLAN 10.
  A. While the AP is in standalone mode, the client will be placed in VLAN 15.
  D. While the AP is in standalone mode, the client will be placed in VLAN 13.
  E. When the AP is in connected mode, the client will be placed in VLAN 13.

• Question 3:

  By default, how long does a Mobility Services Engine wait for an echo response from a Wireless LAN Controller before declaring the neighbor dead?

  A. 10 Seconds
  B. 60 Seconds
  C. 15 Seconds
  D. 30 Seconds
  D. 30 Seconds

  ---

  http://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/2-0/configuration/guide/pi_20_cg/mse.html

• Question 4:

  A network engineer is configuring QoS and sees a DSCP value of 40. To which CoS value will this be mapped?

  A. 4
  B. 3
  C. 5
  D. 2
  E. 1
  C. 5

  ---

  References: http://www.cisco.com/c/en/us/support/docs/wireless-mobility/voice-over-wireless-lan-vowlan/116056-technote-qos-00.html#anc3

• Question 5:

  An engineer wants to identify historical data collected by the Cisco MSE on rogue access points over the past two years. If the Cisco MSE is configured for maximum historical data retention, how many months can be searched?

  A. 24
  B. 36
  C. 6
  D. 12
  D. 12

• Question 6:

  How many APs can be set as master and what is the maximum number of slave APs for FlexConnect AP upgrades in a specific FlexConnect group?

  A. one master and three maximum slave APs per AP model
  B. one master and two backup master AP per AP model
  C. one master and four maximum slave APs per AP model
  D. one master and one backup master AP per AP model
  A. one master and three maximum slave APs per AP model

• Question 7:

  CMX Facebook WiFi can allow access to the network before authentication. Which two of the following options are available? (Choose two)

  A. Allow all the traffic before authentication and intercept HTTPs only.
  B. Allow HTTP traffic only before authentication and block all the traffic.
  C. Allow SNMP traffic only before authentication and block all the traffic.
  D. Allow all the traffic before authentication and intercept HTTP only.
  E. Allow HTTPs traffic only before authentication and block all other traffic.
  B. Allow HTTP traffic only before authentication and block all the traffic.
  D. Allow all the traffic before authentication and intercept HTTP only.

• Question 8:

  Refer to the exhibit.

  

  You have a user who has a device that publishes its own service. What is the user doing from the My Devices Portal?

  A. adding mapping between the MAC address and mDNS
  B. configuring the mDNS service for a device
  C. adding the device to the Cisco ISE device database
  D. assigning exclusive access to a device or a user ID
  D. assigning exclusive access to a device or a user ID

• Question 9:

  On which AP radio or radios is Cisco WGB association and public safety supported?

  A. 5 GHz only
  B. 2.4 GHz only
  C. 2.4, 5, or 4.9 GHz
  D. 2.4 or 5 GHz only
  C. 2.4, 5, or 4.9 GHz

• Question 10:

  What is a realistic way to minimize inter-controller roaming in a large multibuilding campus?

  A. Each controller must belong to a different mobility group.
  B. All APs must join a single controller across the entire campus.
  C. APs in each building must join the same controller.
  D. APs in each building must be load balanced across controllers.
  A. Each controller must belong to a different mobility group.