Cisco 300-360 Online Practice Questions and Exam Preparation

Cisco 300-360 Online Questions & Answers

• Question 211:

  An engineer must gather requirements for an upcoming wireless design in a manufacturing facility. Which requirement causes concerns for the customer?

  A. lossless roaming capability
  B. email connectivity
  C. high throughput multimedia applications
  D. intermittent web traffic
  A. lossless roaming capability

• Question 212:

  An engineer is assigned to replace an older data-grade autonomous wireless network with a Cisco controller-based wireless network to meet Voice over WLAN needs. The customer also wants all existing cable infrastructure to be reused and no new cable be specified. How should the engineer respond to the customer's requirements?

  A. Implement the wireless network with the restraints and decrease the TPC neighbor threshold to increase Tx power to provide overlapping cell coverage at sufficient SNR to provide for Voice over WLAN service.
  B. Implement the wireless network with the restraints and utilize high-gain antenna to provide overlapping cell coverage at sufficient SNR to provide for Voice over WLAN service.
  C. Inform the customer that the network will not likely function as desired and a post install survey with the possibility of some new cable would be recommended.
  D. Inform the customer that it is not possible to provide coverage and quality for Voice over WLAN using existing AP locations and an entire overbuild will be necessary.
  B. Implement the wireless network with the restraints and utilize high-gain antenna to provide overlapping cell coverage at sufficient SNR to provide for Voice over WLAN service.

• Question 213:

  An engineer is performing a predictive RF design of a typical office environment. Which value is the most likely attenuation of a cubical wall for this environment?

  A. 2 dBi
  B. 12 dBd
  C. 1 dB
  D. 12 mW
  A. 2 dBi

• Question 214:

  A wireless engineer is hired to design a network for six buildings with a WLC in each building to support the access points. Which type of wireless architecture is being used?

  A. distributed deployment
  B. autonomous deployment
  C. unified deployment
  D. centralized deployment
  B. autonomous deployment

• Question 215:

  An engineer is concerned with the compliance guidelines for human exposure to a rooftop RF transmitter that has been recently installed. What regulation should be reviewed to ensure proper certification?

  A. OSHA 1910.97
  B. FCC QET Bulletin 65
  C. NFPS Article 810
  D. SCEE Section 28.1
  B. FCC QET Bulletin 65

  ---

  Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic Fields; This revised OET Bulletin 65 has been prepared https://www.fcc.gov/general/oet-bulletins-line

• Question 216:

  You are designing a wireless network for a small square office. The office can be covered wirelessly by using a couple access points, but the customer requests that the Wi-Fi network be "location-ready". Where do you place the access points based on best practices?

  A. in the four corners of the office
  B. two far end corners of the office
  C. one in the center of the office
  D. two placed 80 feet apart
  A. in the four corners of the office

• Question 217:

  During an installation of a wireless network in a country that follows ETSI standards, the customer is requesting to manually set the channels on the 2.4GHz radios. Which channels are recommended for use in this deployment?

  A. 52, 56, 60, 64
  B. 1, 6, 11, 14
  C. 36, 40, 44, 48
  D. 1, 5, 9, 13
  D. 1, 5, 9, 13

• Question 218:

  Which functionality on WLAN controllers and APs is used to periodically reconfigure the 802.11 RF network?

  A. AitMagnet VoFi Analyzer
  B. Cisco Connected Mobile Experience
  C. Cisco CleanAir
  D. Radio Resource Management
  D. Radio Resource Management

• Question 219:

  What are two advantages of conducting an active survey versus a passive survey when verifying RF coverage? (Choose two.)

  A. verifies packet loss
  B. verifies roaming
  C. verifies SNR
  D. verifies signal level
  E. verifies interferers
  A. verifies packet loss
  B. verifies roaming

• Question 220:

  You are designing a network deployment for a state college. The college has six buildings. Each building has a WLC located in the IDF to support access points. Which type of wireless architecture does the deployment represent?

  A. centralized
  B. distributed
  C. cloud
  D. autonomous
  A. centralized