Cisco 300-160 Online Practice Questions and Exam Preparation

Cisco 300-160 Online Questions & Answers

• Question 251:

  You plan to implement a new Cisco Nexus 7000 Series Switch that will have N7K-F132XP-15 F1 modules. How many fabrics modules (FAB 1) do you need to achieve the full F1 module capacity?

  D

• Question 252:

  Which two statements about OTV are true? (Choose two.)

  A. OTV forwards and processes spanning-tree BPDUs between sites to ensure a loop-free topology.
  B. All OTV overlay interfaces must use the same join interface.
  C. OTV provides STP isolation because it does not transmit BPDUs across the overlay
  D. OTV utilizes the IS-IS routing protocol to propagate MAC address reachability information
  E. Multicast support in the transport network is a strict requirement to establish OTV adjacencies.
  F. OTV propagates MAC address reachability information via the underlying IS-IS control-plane.
  C. OTV provides STP isolation because it does not transmit BPDUs across the overlay
  D. OTV utilizes the IS-IS routing protocol to propagate MAC address reachability information

• Question 253:

  Which three options does Cisco Data Mobility Manager provide? (Choose three.)

  A. can change the migration rate to shorten windows during low traffic hours or minimize interference
  B. brings the need for multiple migration solutions
  C. moves from a smaller logical unit number to a larger LUN
  D. manages all capabilities from an easy-to-use GUI
  E. manages all capabilities from CLI
  F. can change the migration rate to shorten windows during high traffic hours or maximize interference
  G. manages some capabilities from an easy-to-use GUI
  A. can change the migration rate to shorten windows during low traffic hours or minimize interference
  C. moves from a smaller logical unit number to a larger LUN
  D. manages all capabilities from an easy-to-use GUI

• Question 254:

  Which two FEX topologies trade deterministic bandwidth for server-link stability during FEX uplink failure? (Choose two.)

  A. port channel
  B. static pinning
  C. virtual port channel
  D. dynamic pinning
  E. Equal-Cost Multipath
  F. RPVST
  A. port channel
  C. virtual port channel

• Question 255:

  Which document is the least relevant as an output deliverable from the design phase?

  A. high-level design
  B. site requirements specification
  C. configurations
  D. migration plan
  C. configurations

• Question 256:

  Which three statements accurately describe end host mode on cisco UCS Fabric interconnect? (choose Three)

  A. The Fabric interconnect must be rebooted to enable end host mode
  B. Network to server unicast traffic is forward to the server only if the traffic arrived on pinned up link mode
  C. RPF and Deja -Vue checks apply to multicast traffic
  D. The uplink port are placed in rapid PVST+ edge trunk state
  E. Mac address learning occurs only on the server ports
  F. The vtp is enabled on fabric interconnect
  A. The Fabric interconnect must be rebooted to enable end host mode
  B. Network to server unicast traffic is forward to the server only if the traffic arrived on pinned up link mode
  E. Mac address learning occurs only on the server ports

• Question 257:

  You are sizing the aggregation layer for a data center. Which two factors influence the size of the TCAM table space on the aggregation data center switches? (Choose two.)

  A. the QoS policies
  B. the configured VLANs
  C. the configured OSPF networks
  D. the configured security access control list policies E the configured OSPF processes
  B. the configured VLANs
  C. the configured OSPF networks

• Question 258:

  Which two characteristics are associated with the access layer of a Data Center Unified Fabric network? (Choose two)

  A. voice, data, and wireless convergence
  B. no packet manipulation
  C. QoS--policing
  D. routing manipulation and filtering
  E. QoS - classification and queuing
  A. voice, data, and wireless convergence
  E. QoS - classification and queuing

• Question 259:

  You plan to implement a new data center solution that will use an IGP. Which routing protocol must you use in a large full-mesh network that requires fast convergence and scalability?

  A. LDP
  B. BGP
  C. RIP
  D. EIGRP
  E. IS-IS
  E. IS-IS

• Question 260:

  What are traits of a routing protocol used in a data center? (Choose two.)

  A. proprietary and secure
  B. fast route convergence
  C. support for ECMP
  D. support for LACP
  E. support for large hop limit
  B. fast route convergence
  C. support for ECMP