Cisco 300-160 Online Practice Questions and Exam Preparation

Cisco 300-160 Online Questions & Answers

• Question 151:

  Which two options are advantages when using NPIV? (Choose two.)

  A. allows a single physical N-Port to have single WWPNs, and therefore single N-Port IDs, associated with it
  B. NPIV-enabled physical N-Port can subsequently issue additional commands to register more WWPNs and receive more N-Port IDs (one for each WWPN).
  C. allows a 'single' physical N-Port to have multiple WWPNs, and therefore multiple N-Port IDs, associated with it
  D. NPV-enabled physical N-Port can subsequently issue additional commands to register more WWPNs and receive more N-Port IDs (one for each WWPN).
  E. allows 'multiple' single physical N-Port to have multiple WWPNs, and therefore multiple N-Port IDs, associated with it
  F. N-Port on the physical host would have only a single WWPN (and N-Port ID).
  B. NPIV-enabled physical N-Port can subsequently issue additional commands to register more WWPNs and receive more N-Port IDs (one for each WWPN).
  C. allows a 'single' physical N-Port to have multiple WWPNs, and therefore multiple N-Port IDs, associated with it

• Question 152:

  Which protocol does the Data Center Bridging Capability Exchange protocol use to discover and initialize DCB-compliant devices?

  A. LLDP
  B. ETS
  C. PFC
  D. FIP
  E. TCP
  A. LLDP

• Question 153:

  if you are connecting a Cisco UCS Fabric Interconnect in it's default mode to a SAN, what is the operating mode?

  A. trunk
  B. NPIV mode
  C. switching
  D. NPV mode
  B. NPIV mode

• Question 154:

  What is the purpose of the Cisco UCS TCO/ROI Advisor tool?

  A. to design the components of Cisco UCS solution
  B. to compare an existing environment to a Cisco UCS solution from a cost prospective
  C. to measure the current system workloads across various elements of the IT infrastructure
  D. to plan for system capacity optimization through detailed utilization analysis
  B. to compare an existing environment to a Cisco UCS solution from a cost prospective

• Question 155:

  Refer to the exhibit.

  

  Customer would like to utilize Cisco Nexus7000 series switches as converged Ethernet aggregation and SAN core switch in their new data center design. The switch can be connected to a Cisco MDS 9500 Series switch in a three-tier edge-core-edge SAN design as shown in the exhibit. Which technology makes this type of design possible?

  A. FC forwarding
  B. Multi-hop FCoE
  C. iSCSI gateway to increase network bandwidth
  D. vPC+
  E. NAS gateway at the aggregation layer
  B. Multi-hop FCoE

• Question 156:

  Which option should be included in the data center design if it must support zone-based firewalling on a per virtual machine basis, while preserving full virtual machine mobility without manual intervention?

  A. Cisco Virtual Services Gateway with vPath
  B. Cisco Nexus 1000v Advanced Edition with Prime Network Services Controller
  C. Cisco Nexus 5500 Series Layer 3 module
  D. strict unicast RPF
  B. Cisco Nexus 1000v Advanced Edition with Prime Network Services Controller

• Question 157:

  Which two options are business requirements that drive the data center design? (Choose two.)

  A. Increase virtual machine-to-host ratio.
  B. Reduce power consumption.
  C. Reduce latency within the network.
  D. Migrate to FCoE.
  E. Reduce operation expenditure.
  F. Increase network throughput.
  B. Reduce power consumption.
  E. Reduce operation expenditure.

• Question 158:

  Refer to the exhibit.

  

  Which two descriptions of the configuration are true? (Choose two.)s

  A. The STP is disabled on the vPC peer device.
  B. The device is a secondary vPC device.
  C. The device is a primary vPC device.
  D. There are 55 vPC domains configured onthe device.
  E. The device is configured to act as an active gateway for packets destined for the MAC address of the peer device.
  A. The STP is disabled on the vPC peer device.
  D. There are 55 vPC domains configured onthe device.

• Question 159:

  You are planning to build a new SAN network that will have 25 4-Gbps host ports and two 8-Gbps storage uplink ports. Which option is the oversubscription ratio on a Cisco MDS switch?

  A. 7:1
  B. 6:1
  C. 10:3
  D. 5:3
  E. 4:1
  B. 6:1

• Question 160:

  Which of the following is true with respect to Cisco Adapter FEX?

  A. Cisco Adapter FEX is only supported on vSwitch.
  B. Cisco Adapter FEX enables the server adapter to be logically partitioned into multiple vNICs.
  C. Cisco Adapter FEX does not provide architectural flexibility.
  D. Cisco Adapter FEX increases the number of cables in the data center.
  B. Cisco Adapter FEX enables the server adapter to be logically partitioned into multiple vNICs.