VMware 2V0-602 Online Practice Questions and Exam Preparation

VMware 2V0-602 Online Questions & Answers

• Question 121:

  Which three actions can be executed when an alarm is triggered? (Choose three.)

  A. Send an email.
  B. Send an SNMP trap.
  C. Run a script or command.
  D. Run an Orchestrator workflow.
  E. Send a trigger to syslog.
  A. Send an email.
  B. Send an SNMP trap.
  C. Run a script or command.

• Question 122:

  An administrator has configured an alarm to be notified when a virtual machine meets two conditions:

  high virtual CPU

  high active memory consumption

  The alarm is malfunctioning and triggering when either condition is met instead of both.

  What can be done to correct the issue?

  A. Edit the alarm and select Trigger if ALL of the following conditions are satisfied.
  B. Edit the alarm and select Trigger if ANY of the following conditions are satisfied.
  C. Create two separate alarms, one for CPU and one for memory.
  D. Delete the existing alarm and create a new event based alarm.
  A. Edit the alarm and select Trigger if ALL of the following conditions are satisfied.

• Question 123:

  Which is a valid requirement for deploying the vCenter Server Appliance 6.x to a DRS cluster?

  A. One ESXi host in the cluster must not be in maintenance mode or lockdown mode.
  B. At least one host in the cluster must not be in maintenance mode or lockdown mode.
  C. One ESXi host in the cluster must not be in lockdown mode.
  D. All ESXi hosts in the cluster must not be in maintenance mode.
  B. At least one host in the cluster must not be in maintenance mode or lockdown mode.

• Question 124:

  Refer to the Exhibit. An administrator is configuring an ESXi 6.x host to use multiple NICs to resolve a management network redundancy error. After configuring a second NIC, the server is not able to communicate when the primary

  connection is taken down.

  The administrator analyzes the Exhibit shown here.

  

  Based on the exhibit, what is the likely cause of the issue?

  A. vmnic4 is not attached to a vSwitch.
  B. vmnic2 is not connected to a physical switch.
  C. E1000 is the incorrect NIC Driver for this card.
  D. There is a MAC address conflict on the network.
  B. vmnic2 is not connected to a physical switch.

• Question 125:

  An ESXi 6.x host consists of 24 logical cores. Hyperthreading is enabled on the host. What is the maximum number of vCPUs that can be assigned to a virtual machine on this host?

  A. 24
  B. 48
  C. 64
  D. 128
  A. 24

• Question 126:

  Which two actions are required when enabling vFlash Read Cache for a virtual machine's virtual disk? (Choose two.)

  A. A value in the Virtual Flash Read Cache text box must be entered.
  B. A Flash Resource Pool for Cache size reservation must be entered.
  C. The Device backing and the block size must be configured.
  D. The Enable virtual flash host swap cache check box must be selected.
  A. A value in the Virtual Flash Read Cache text box must be entered.
  D. The Enable virtual flash host swap cache check box must be selected.

• Question 127:

  Which two options can change the thin provisioned disk to thick provisioned? (Choose two.)

  A. Use vMotion to migrate the VM to another ESXi host without moving the disks.
  B. Use Storage vMotion of the running VM to the same datastore and select Thick Provision.
  C. Power off the VM, locate the VMDK disk in the Datastore browser, right-click that and select Inflate.
  D. Use Storage vMotion of the running VM to another datastore and select Thick Provision.
  C. Power off the VM, locate the VMDK disk in the Datastore browser, right-click that and select Inflate.
  D. Use Storage vMotion of the running VM to another datastore and select Thick Provision.

  ---

  https://pubs.vmware.com/vsphere-65/index.jsp?topic=%2Fcom.vmware.vsphere.vm_admin.doc%2FGUID-E8F50BEC-F575-4AB1-BC77- D9A13CDBDCF7.html

• Question 128:

  Which type of network traffic is used for vSphere High Availability (HA) by default?

  A. VM Network traffic
  B. Management network traffic
  C. vMotion network traffic
  D. ISCSI Port Binding network traffic
  B. Management network traffic

• Question 129:

  Which two options can be monitored when creating a new Alarm Definition? (Choose two.)

  A. specific actions of a user
  B. other alarms defined for the object
  C. specific conditions or state
  D. specific event occurring on the object
  C. specific conditions or state
  D. specific event occurring on the object

• Question 130:

  A Fault Tolerance (FT) virtual machine with four vCPUs is experiencing high latency when performing ICMP and Application tests. What are three potential causes that may be attributing to this latency? (Choose three.)

  A. The FT network has insufficient bandwidth and is running on a 1GB Link.
  B. The FT network is on a particularly high latency link.
  C. The FT network has been configured with Network I/O Control.
  D. The FT virtual machine is running an e1000 network adapter.
  E. The FT virtual machine is running on poor performing network-based storage.
  A. The FT network has insufficient bandwidth and is running on a 1GB Link.
  B. The FT network is on a particularly high latency link.
  C. The FT network has been configured with Network I/O Control.