F5 201 Online Practice Questions and Exam Preparation

F5 201 Online Questions & Answers

• Question 11:

  A BIG-IP Administrator needs to remove a pool specific health monitor. There is a pool named Best Pool with two members, one named Best pool member and one named Best pool member2. In the Local Traffic section of the administrative GUI, which stops should the BIG-IP Administrator take to remove a pool level monitor?

  A. Pool > Pool List > Best Pool > Members > Health Monitors
  B. Nodes > Node List> Best _pool_memberl > Heath Monitors
  C. Monitors > Monitor Name> Instances
  D. Pool > Pool List> Best Pool > Health Monitors
  D. Pool > Pool List> Best Pool > Health Monitors

• Question 12:

  The BIG-IP Administrator needs to perform a BIG-IP device upgrade to the latest version of TMOS. Where can the administrator obtain F5 documentation on upgrade requirements?

  A. AskF5
  B. DevCentral
  C. Bug Tracker
  D. iHealth
  A. AskF5

• Question 13:

  A BIG-IP Administrator needs to restore a UCS file to an F5 device using the Configuration Utility. Which section of the Configuration Utility should the BIG-IP Administrator access to perform this task?

  A. Local Traffic > Virtual Servers
  B. Local Traffic > Policies
  C. System > Archives
  D. System > Configuration
  C. System > Archives

• Question 14:

  A BIG-IP device has only LTM and ASM modules provisioned. Both have nominal provisioning level. The BI6-IP Administrator wants to dedicate more resources to the LTM module. The ASM module must remain enabled. Which tmsh command should the BIG-IP Administrator execute to obtain the desired result?

  A. modify/sys provision asm level minimum
  B. modify /sys provision Itm level dedicated
  C. modify /sys provision asm level none
  D. modify /sys provision Itm level minimum
  A. modify/sys provision asm level minimum

• Question 15:

  A BIG-IP Administrator suspects that one of the BIG-IP device power supplies is experiencing power outages. Which log file should the BIG-IP Administrator check to verify the suspicion?

  A. /war /log/daemon.log
  B. /var/log/kern.log
  C. /var/log/ltm
  D. /var/log/audit
  C. /var/log/ltm

• Question 16:

  Assuming that systems are synchronized, which action could take place if the fail over cable is connected correctly and working properly, but the systems cannot communicate over the network due to external network problems?

  A. If network failover is enabled, the standby system will assume the active mode.
  B. Whether or not network failover is enabled, the standby system will stay in standby mode.
  C. Whether or not network failover is enabled, the standby system will assume the active mode.
  D. If network failover is enabled, the standby system will go into active mode but only until the network recovers.
  B. Whether or not network failover is enabled, the standby system will stay in standby mode.

• Question 17:

  A BIG-IP Administrator reviews the log files to determine the cause of a recent problem and finds the following entry. Mar 27.07.58.48 local/BIG-IP notice mcpd {5140} 010707275 Pool member 172.16.20.1.10029 monitor status down. What is the cause of this log message?

  A. The pool member has been disabled.
  B. The pool member has been marked as Down by the BIG-IP Administrator.
  C. The monitor attached to the pool member needs a higher timeout value.
  D. The monitor attached to the pool member has failed.
  D. The monitor attached to the pool member has failed.

• Question 18:

  Given that VLAN failsafe is enabled on the external VLAN and the network that the active BIG-IP's external VLAN is connected to has failed, which statement is always true about the results?

  A. The active system will note the failure in the HA table.
  B. The active system will reboot and the standby system will go into active mode.
  C. The active system will failover and the standby system will go into active mode.
  D. The active system will restart the traffic management module to eliminate the possibility that BIG-IP is the cause for the network failure.
  A. The active system will note the failure in the HA table.

• Question 19:

  Which method is recommended for creating a new user from the CLI?

  A. Run f5adduser username' then 'f5passwd username' from bash or tmsh
  B. Run tmsh create auth user username prompt for password' from bash
  C. edit bigip.conf to add the new user and the user's clear-text password
  D. Run useradd username' then 'passwd username' from bash tmsh
  B. Run tmsh create auth user username prompt for password' from bash

• Question 20:

  When configuring a pool member's monitor, which three association options are available? (Choose three.)

  A. inherit the pool's monitor
  B. inherit the node's monitor
  C. configure a default monitor
  D. assign a monitor to the specific member
  E. do not assign any monitor to the specific member
  A. inherit the pool's monitor
  D. assign a monitor to the specific member
  E. do not assign any monitor to the specific member