Cisco 200-125 Online Practice Questions and Exam Preparation

Cisco 200-125 Online Questions & Answers

• Question 81:

  Which feature facilitate the tagging of a specific VLAN?

  A. Routing
  B. Hair pinning
  C. Encapsulation
  D. Switching
  C. Encapsulation

• Question 82:

  Drag and Drop.

  Select and Place:

  

  

• Question 83:

  Refer to the Exhibit.

  

  Which two routes are using a link state protocol? (Choose two)

  A. 172.20.30.21
  B. 192.168.11.0/24
  C. 172.20.20.21
  D. 172.20.10.21
  E. 192 168 10 0/24
  B. 192.168.11.0/24
  C. 172.20.20.21

• Question 84:

  Which two statements about TACACS+ are true? (Choose two.)

  A. It can run on a UNIX server.
  B. It authenticates against the user database on the local device.
  C. It is more secure than AAA authentication.
  D. It is enabled on Cisco routers by default.
  E. It uses a managed database.
  A. It can run on a UNIX server.
  E. It uses a managed database.

• Question 85:

  Refer to the exhibit.How will switch SW2 handle traffic from VLAN 10 on SW1?

  

  A. It sends the traffic to VLAN 100
  B. It sends the traffic to VLAN 1
  C. It drops the traffic
  D. It sends the traffic to VLAN 10
  A. It sends the traffic to VLAN 100

• Question 86:

  In which two ways can you prevent recursive routing in a tunneled environment? (Choose two)

  A. Configure routes through the tunnel with a lower metric than other routes.
  B. Configure route filtering to prevent the tunnel endpoints from learning each other through the tunnel.
  C. Enable QoS on the link.
  D. Configure routes through the tunnel with a higher metric than other routes.
  E. configure GRE keepalives on the tunnel interface.
  B. Configure route filtering to prevent the tunnel endpoints from learning each other through the tunnel.
  E. configure GRE keepalives on the tunnel interface.

• Question 87:

  Which command can you enter in a network switch configuration so that learned mac addresses are saved in configuration as they connect ?

  A. Switch(confg-if)#Switch port-security
  B. Switch(confg-if)#Switch port-security Mac-address sticky
  C. Switch(confg-if)#Switch port-security maximum 10
  D. Switch(confg-if)#Switch mode access
  B. Switch(confg-if)#Switch port-security Mac-address sticky

• Question 88:

  Which option is the primary purpose of traffic shaping?

  A. Providing best-effort service
  B. limiting bandwidth usage
  C. enabling policy-based routing
  D. enabling dynamic flow identification
  B. limiting bandwidth usage

• Question 89:

  Which Ethernet interface command is present when you boot a new Cisco router for the first time?

  A. speed 100
  B. shutdown
  C. ip address 192.168.1.1 255.255.255.0
  D. duplex half
  B. shutdown

• Question 90:

  Which VTP mode prevents you from making changes to VLANs?

  A. server
  B. off
  C. client
  D. transparent
  C. client