Cisco 200-125 Online Practice Questions and Exam Preparation

Cisco 200-125 Online Questions & Answers

• Question 691:

  Which command can be used from a router to verify the Layer 3 path to a host?

  A. tracert address
  B. traceroute address
  C. telnet address
  D. ssh address
  B. traceroute address

• Question 692:

  Refer to the exhibit.

  

  An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?

  A. data link layer
  B. application layer
  C. access layer
  D. session layer
  E. network layer
  E. network layer

  ---

  The command ping uses ICMP protocol, which is a network layer protocol used to propagate control message between host and router. The command ping is often used to verify the network connectivity, so it works at the network layer.

• Question 693:

  Which statement describes VRRP object tracking?

  A. It monitors traffic flow and link utilization.
  B. It ensures the best VRRP router is the virtual router master for the group.
  C. It causes traffic to dynamically move to higher bandwidth links.
  D. It thwarts man-in-the-middle attacks.
  B. It ensures the best VRRP router is the virtual router master for the group.

  ---

  Object tracking is the process of tracking the state of a configured object and uses that state to determine the priority of the VRRP router in a VRRP group.

• Question 694:

  Refer to exhibit. Which command can you enter to verify link speed and duplex setting on the interface?

  

  A. router# show protocols
  B. router#show startup-config
  C. router#show line
  D. router#show interface gig0/1
  D. router#show interface gig0/1

• Question 695:

  Which feature or method can you use to isolate physical layer problems on a serial link?

  A. autonegotiation
  B. UDLD
  C. protocol analyzer
  D. loopback tests
  A. autonegotiation

• Question 696:

  Refer to the exhibit.

  

  If R1 receives a packet destined to 172.16.1.1, to which IP address does it send the

  packet ?

  A. 192.168.14.4
  B. 192.168.12.2
  C. 192.168.13.3
  D. 192.168.15.5
  A. 192.168.14.4

• Question 697:

  Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?

  

  A. trunk mode mismatches
  B. vlans that do not correspond to a unique IP subnet
  C. native vlan mismatches
  D. allowing only vlan 2 on the destination.
  C. native vlan mismatches

• Question 698:

  which value indicate the distance from the ntp authoritative time source?

  A. Priority
  B. Location
  C. layer
  D. Stratum
  D. Stratum

• Question 699:

  How many bits can be used to identify unique hosts in the address range for network 10.0.0.0/8?

  A. 8
  B. 16
  C. 24
  D. 32
  C. 24

• Question 700:

  Which effect of the terminal monitor command is true ?

  A. It puts the device into global configuration mode
  B. It configures the device to log messages to the console
  C. It displays the configuration of the syslog server
  D. It configures a syslog server
  B. It configures the device to log messages to the console