Riverbed 199-01 Online Practice Questions and Exam Preparation

Riverbed 199-01 Online Questions & Answers

• Question 171:

  When troubleshooting a datastore wrapping alarm with 1 day wrapping notification configured, which of the following should be examined? (Select 2)

  A. If the unit was mis-sized
  B. If stream based encrypted traffic is being sent across the link as optimized
  C. If your fixed-target rules are pointing to the correct Steelhead appliance
  D. If Connection Forwarding was properly configured
  A. If the unit was mis-sized
  B. If stream based encrypted traffic is being sent across the link as optimized

• Question 172:

  Regarding the registering of Steelhead appliances,

  A. Local appliances (on the same IP subnet) are automatically registered every time because their 10-byte probe is intercepted by the CMC appliance
  B. Remote appliances are registered when a fixed-target rule is applied to the appliance directing it to the CMC appliance
  C. Remote appliances are registered by proxy via the server-side Steelhead appliance
  D. Remote appliances are registered manually when they have not auto-registered with the CMC appliance
  E. Local appliances can only be registered manually, since fixed-target rules may only be applied to remote Steelhead appliances
  D. Remote appliances are registered manually when they have not auto-registered with the CMC appliance

• Question 173:

  The alerting threshold for CPU utilization is 70% and the reset threshold is 50%. Which of the following situations will result in an alarm being triggered? (Select 2)

  A. Initial utilization of 30% becomes 75%
  B. Drop from 90% of utilization to 70%
  C. Initial utilization of 73% becomes 90%
  D. Drop from 75% of utilization to 48% and shot up to 68%
  E. Drop from 75% of utilization to 48% and shot up to 78%
  A. Initial utilization of 30% becomes 75%
  E. Drop from 75% of utilization to 48% and shot up to 78%

• Question 174:

  Which of the following methods can be used to reduce the load on a router configured to use outbound interface WCCP redirection? (Select 3)

  A. Using inbound interface redirection instead
  B. Use fixed-target rules and remove WCCP on the WAN facing interfaces
  C. Use Redirect lists to control what traffic gets redirected
  D. Use the router command "load interval 30" to restrict WCCP to use 30% of the CPU
  E. Use Event Element Manager (EEM) to load balance between a clustered Steelhead appliance deployment
  A. Using inbound interface redirection instead
  B. Use fixed-target rules and remove WCCP on the WAN facing interfaces
  C. Use Redirect lists to control what traffic gets redirected

• Question 175:

  Refer to the exhibit.

  

  A customer has a server-side out-of-path deployment, and reports that connections from some of their remote branch offices are not being optimized. What is the most likely problem?

  A. A missing fixed-target rule on the server-side Steelhead appliance
  B. A missing fixed-target rule on the client-side Steelhead appliance
  C. The WAN interface is connected to the server-side Steelhead appliance
  D. The LAN interface is connected to the server-side Steelhead appliance
  E. Using port 7810 in the fixed-target rule instead of 7800
  B. A missing fixed-target rule on the client-side Steelhead appliance

• Question 176:

  A customer wants to optimize traffic from remote VPN sites to DMZ servers in the data center shown in the accompanying exhibit.

  

  The customer would also like to deploy their data center Steelhead appliance in a way that would allow them to keep transparency to the LAN servers, and allow the LAN servers to initiate optimized connections to remote sites. The current network architecture can satisfy these requirements by using which following deployment method?

  A. In-path
  B. Out-of-path
  C. WCCP/PBR
  D. Hybrid Mode
  E. C and D
  D. Hybrid Mode

• Question 177:

  Which authentication methods are available to the Steelhead Mobile Controller?

  A. Local and LDAP
  B. Local, NIS, and LDAP
  C. Local, RADIUS, and TACACS+
  D. Local, RADIUS, and Active Directory
  E. NTLM and Kerberos
  C. Local, RADIUS, and TACACS+

• Question 178:

  In an existing deployment, all connections appear to be unoptimized. The Current Connections page lists the connections as pass-through.

  

  The logs indicate admission control "Jan 19 18:44:56 client sport[343]: [admission_control.WARN] Pausing intercept." What are some possible ways to alleviate the problem? (Select 2)

  A. Verify that there is no SMB Signing on the server
  B. Ensure that there are no Opportunistic Lock issues
  C. Disable or reduce the connection timeout of MAPI prepopulation
  D. Investigate if there is a virus on a client trying to propagate itself
  E. Validate that NFS v2 broadcasts are enabled
  C. Disable or reduce the connection timeout of MAPI prepopulation
  D. Investigate if there is a virus on a client trying to propagate itself

• Question 179:

  What should you do when you receive the following message?

  [intercept.NOTICE] sending kickoff RST: 10.35.178.41:1169 -> 10.110.141.30:1031.

  A. Nothing. This is just a notice message.
  B. Verify whether the "Reset Existing Client Connections on Start Up" option is checked and uncheck it
  C. Switch off the Steelhead appliance
  D. Create a specific pass-through rule to bypass the above source and destination hosts
  E. Restart the Steelhead appliance
  B. Verify whether the "Reset Existing Client Connections on Start Up" option is checked and uncheck it

• Question 180:

  The SteelCentral Controller for SteelHead Mobile is rebooted or becomes unreachable from the end user mobile client. What happens to their network connections?

  A. The end user's existing and new connections continue to be optimized as per policy.
  B. SSL trusts will fail and SSL will be passed through, all other traffic is unaffected.
  C. The end user's optimized connections continue but new connections are passed through.
  D. The end user's network connections terminate and they must wait for the controller to come back online.
  E. The end user's optimized connections are reset and restart in pass-through mode.
  A. The end user's existing and new connections continue to be optimized as per policy.