CompTIA SG0-001 Online Practice Questions and Exam Preparation

CompTIA SG0-001 Online Questions & Answers

• Question 211:

  Which of the following tools would be used to securely administer and configure various network devices?

  A. Telnet
  B. HTTP
  C. SIMMFV1
  D. SSH
  D. SSH

• Question 212:

  When comparing 7,200 RPM disk drives to 15,000 RPM disk drives, the 15,000 RPM disk drives will have:

  A. slower rotational speed.
  B. lower IOPs capability.
  C. lower latency.
  D. slower throughput.
  C. lower latency.

• Question 213:

  The ability to move source data from enterprise disk to secondary disk is known as which of the following?

  A. Deduplication
  B. Tiering
  C. Shared access
  D. Multipathing
  B. Tiering

• Question 214:

  Given a scenario in which a higher than average number of disk failures are observed in one particular corner of a datacenter floor, which of the following is the MOST likely cause?

  A. Inadequate division of power circuits
  B. Inadequate number of cables
  C. Inadequate cooling
  D. Inadequate floor support
  C. Inadequate cooling

• Question 215:

  A technician has completed a replacement of the customer's 1Gbps FC switches with new 4Gbps FC switches. All HBAs in the servers and storage arrays were also upgraded. To save money, the customer installed into the original cable plant. After all zoning changes were completed, and devices were brought online, the servers are not able to connect properly to the storage arrays. Which of the following is the MOST likely problem?

  A. The servers are not running the correct operating system to use 4Gbps.
  B. Zoning needs to be changed for the new switch Domain IDs.
  C. The cable plant is not up to specification for the 4Gbps data rates.
  D. The storage arrays do not support the new adapter firmware.
  C. The cable plant is not up to specification for the 4Gbps data rates.

• Question 216:

  Which of the following requires a MINIMUM of three drives and can survive the loss of up to any two drives?

  A. RAID 1
  B. RAID 0+1
  C. RAID 5
  D. RAID 6
  D. RAID 6

• Question 217:

  Which of the following will MOST likely remove a single point of failure in the storage network architecture?

  A. Adequate heating and ventilation to each rack
  B. Floor and rack loading within acceptable weight limits
  C. Multiple power circuits available in each rack
  D. Maintained and tested fire suppression equipment
  C. Multiple power circuits available in each rack

• Question 218:

  Which of the following is an open management standard specifically for storage?

  A. SNMP
  B. SLP
  C. SMI-S
  D. SMTP
  C. SMI-S

• Question 219:

  Which of the following connector types would be used to interface with iSCSI based storage?

  A. IEEE 1394
  B. RJ-45
  C. DB-25
  D. HD68
  B. RJ-45

• Question 220:

  A system administrator has completed the configuration of the fiber channel switch. All switch ports have been configured the same way, since they connect similarserver hardware withsimilar capabilities and configuration. One of the servers is unable to see its storage. The system administrator moves the server's current connection to a different and unused fiber channel port and the server's storage is now available.

  Which of the following is the MOST likely reason for the server not being able to see its storage in its original configuration?

  A. Bad MAU
  B. Bad fiber cable
  C. Bad SFP
  D. Bad NIC
  C. Bad SFP