Fortinet Fortinet Certifications NSE4_FGT-7.0 Questions & Answers

• Question 131:

  Which two inspection modes can you use to configure a firewall policy on a profile-based next-generation firewall (NGFW)? (Choose two.)

  A. Proxy-based inspection

  B. Certificate inspection

  C. Flow-based inspection

  D. Full Content inspection

  Correct Answer: AC

• Question 132:

  Which statement about the policy ID number of a firewall policy is true?

  A. It is required to modify a firewall policy using the CLI.

  B. It represents the number of objects used in the firewall policy.

  C. It changes when firewall policies are reordered.

  D. It defines the order in which rules are processed.

  Correct Answer: A

• Question 133:

  Refer to the exhibits.

  

  The SSL VPN connection fails when a user attempts to connect to it. What should the user do to successfully connect to SSL VPN?

  A. Change the SSL VPN port on the client.

  B. Change the Server IP address.

  C. Change the idle-timeout.

  D. Change the SSL VPN portal to the tunnel.

  Correct Answer: A

  Reference: https://docs.fortinet.com/document/fortigate/5.4.0/cookbook/150494

• Question 134:

  Refer to the exhibits to view the firewall policy (Exhibit A) and the antivirus profile (Exhibit B).

  

  

  Which statement is correct if a user is unable to receive a block replacement message when downloading an infected file for the first time?

  A. The firewall policy performs the full content inspection on the file.

  B. The flow-based inspection is used, which resets the last packet to the user.

  C. The volume of traffic being inspected is too high for this model of FortiGate.

  D. The intrusion prevention security profile needs to be enabled when using flow-based inspection mode.

  Correct Answer: B

  ONL"; If the virus is detected at the";STAR"; of the connection, the IPS engine sends the block replacement message immediately When a virus is detected on a TCP session (FIRST TIME), but where";SOME PACKET"; have been already forwarded to the receiver, FortiGate "resets the connection" and does not send the last piece of the file. Although the receiver got most of the file content, the file has been truncated and therefore, can't be opened. The IPS engine also caches the URL of the infected file, so that if a "SECOND ATTEMPT" to transmit the file is made, the IPS engine will then send a block replacement message to the client instead of scanning the file again.

  In flow mode, the FortiGate drops the last packet killing the file. But because of that the block replacement message cannot be displayed. If the file is attempted to download again the block message will be shown.

• Question 135:

  Refer to the exhibit showing a debug flow output.

  

  Which two statements about the debug flow output are correct? (Choose two.)

  A. The debug flow is of ICMP traffic.

  B. A firewall policy allowed the connection.

  C. A new traffic session is created.

  D. The default route is required to receive a reply.

  Correct Answer: AC

  Reference: https://docs.fortinet.com/document/fortigate/6.2.3/cookbook/54688/debugging-the-packet-flow

• Question 136:

  A network administrator wants to set up redundant IPsec VPN tunnels on FortiGate by using two IPsec VPN tunnels and static routes.

  1.

  All traffic must be routed through the primary tunnel when both tunnels are up

  2.

  The secondary tunnel must be used only if the primary tunnel goes down

  3.

  In addition, FortiGate should be able to detect a dead tunnel to speed up tunnel failover

  Which two key configuration changes are needed on FortiGate to meet the design requirements? (Choose two,)

  A. Configure a high distance on the static route for the primary tunnel, and a lower distance on the static route for the secondary tunnel.

  B. Enable Dead Peer Detection.

  C. Configure a lower distance on the static route for the primary tunnel, and a higher distance on the static route for the secondary tunnel.

  D. Enable Auto-negotiate and Autokey Keep Alive on the phase 2 configuration of both tunnels.

  Correct Answer: BC

  B - because the customer requires the tunnels to notify when a tunnel goes down. DPD is designed for that purpose. To send a packet over a firewall to determine a failover for the next tunnel after a specific amount of time of not receiving a response from its peer.

  C - remember when it comes to choosing a route with regards to Administrative Distance. The route with the lowest distance for that particular route will be chosen. So, by configuring a lower routing distance on the primary tunnel, means that the primary tunnel will be chosen to route packets towards their destination.

• Question 137:

  Which two statements about FortiGate FSSO agentless polling mode are true? (Choose two.)

  A. FortiGate uses the AD server as the collector agent.

  B. FortiGate uses the SMB protocol to read the event viewer logs from the DCs.

  C. FortiGate does not support workstation check.

  D. FortiGate directs the collector agent to use a remote LDAP server.

  Correct Answer: BD

  Reference: https://kb.fortinet.com/kb/documentLink.do?externalID=FD47732

• Question 138:

  Which statement about video filtering on FortiGate is true?

  A. Full SSL Inspection is not required.

  B. It is available only on a proxy-based firewall policy.

  C. It inspects video files hosted on file sharing services.

  D. Video filtering FortiGuard categories are based on web filter FortiGuard categories.

  Correct Answer: B

  Reference: https://docs.fortinet.com/document/fortigate/7.0.0/new-features/190873/video-filtering

• Question 139:

  Which three options are the remote log storage options you can configure on FortiGate? (Choose three.)

  A. FortiCache

  B. FortiSIEM

  C. FortiAnalyzer

  D. FortiSandbox

  E. FortiCloud

  Correct Answer: BCE

  Reference: https://docs.fortinet.com/document/fortigate/6.0.0/handbook/265052/logging-and-reportingoverview

• Question 140:

  Which two configuration settings are synchronized when FortiGate devices are in an active- active HA cluster? (Choose two.)

  A. FortiGuard web filter cache

  B. FortiGate hostname

  C. NTP

  D. DNS

  Correct Answer: CD