Nutanix NCA-5.15 Online Practice Questions and Exam Preparation

Nutanix NCA-5.15 Online Questions & Answers

• Question 1:

  A customer requires the ability to block all network traffic between their VDI VMs and their application VMs running on their Nutanix AHV clusters. What Nutanix product would meet this requirement?

  A. Beam
  B. Calm
  C. Era
  D. Flow
  D. Flow

• Question 2:

  Refer to the exhibit.

  

  During VM creation, an administrator clicked on Add New NIC, but there is nothing in the Network Name dropdown list. What is causing this issue?

  A. No physical NICs have been allocated for user VMs
  B. The nodes nave no NiCs attached to them
  C. Only 1G NIC is attached to the Nutanix nodes
  D. A network was not created during Network Configuration
  D. A network was not created during Network Configuration

• Question 3:

  An administrator notices that a VM is slow and unresponsive. The administrator wants to compare performance to other VMs on cluster. Which chart type is best suited to display multiple VM performance metrics for diagnosis?

  A. Dashboard Chart
  B. Entity Chart
  C. Analysis Chart
  D. Metric Chart
  D. Metric Chart

• Question 4:

  Refer to the exhibit.

  

  Management has tasked an administrator to restore the VM, VMforQuestion to a previous point in time (3:20pm), to recover from a corrupted set of files. Which snapshot should the administrator choose, and which action(s) should be executed?

  A. Snapshot 2 Details review restore points. then Clone
  B. Snapshot 2 Restore
  C. Snapshot 1, Restore
  D. Snapshot 1 Details, review restore points. then Clone
  D. Snapshot 1 Details, review restore points. then Clone

• Question 5:

  Which Nutanix component can be placed into a third site, in order to assist the primary and secondary sites during a failure event?

  A. Backup Server
  B. Witness VM
  C. Prism Central
  D. Controller VM
  B. Witness VM

• Question 6:

  Refer to the exhibit.

  

  An administrator notices that the Data Resiliency Statue of some components has been reduced to 0. making it impossible to support a

  node failure in the cluster.

  What type of failure is most likely the cause of this issue?

  A. Block
  B. Disk
  C. CVM
  D. Nods
  C. CVM

• Question 7:

  Which two CVM components are used to provide data locality? (Choose two.)

  A. Logical Unit
  B. Unified Cache
  C. Extent Store
  D. Volume Group
  B. Unified Cache
  C. Extent Store

• Question 8:

  An application owner had reported that an AHV-based critical application VM is performing very slowly. After initial diagnostics, it has been observed that the CPU utilization is significantly higher than normal. What two actions should the administrator take on this VM without shutting it down? (Choose two.)

  A. Increase number of vCPU in Prism Element
  B. Configure additional cores in acli
  C. Ensure CPU hot-add is supported by the Guest O
  D. Use PrismElement to increase the number of cores
  A. Increase number of vCPU in Prism Element
  C. Ensure CPU hot-add is supported by the Guest O

• Question 9:

  An administrator is upgrading a current three-node Nutanix cluster with new HCI nodes. Currently, the environment is based on a Single two-unit chassis hosted in one cabinet. By simply changing the system form factor, what new level of resiliency may this customer achieve?

  A. Rack awareness
  B. Block awareness
  C. Metro Availability
  D. Better replication factor
  B. Block awareness

• Question 10:

  What is required to schedule VM snapshots?

  A. Categories
  B. Consistency Group
  C. Volume Group
  D. Protection Domain
  D. Protection Domain