A network administrator plans to install network connectivity at a new remote office location. The administrator is concerned about how to troubleshoot network connectivity issues and reconfigure the remote router. The technician should use:
A. an SD card with a backup configuration
B. a TFTP server on the main network for backup configurations
C. a modem using POTS.
D. a second Ethernet interface for remote access.
A user has called the help desk with a problem reaching certain servers within the organization. The organization is using RFC 1819 for internal networks. The servers having trouble are configured with the following IP addresses: 192. 130.
135. 5 and 192. 130. 135. 6.
The user cannot connect to the correct servers. Which of the following explain why this is happening to the user?
A. The network has been configured with an inappropriate scheme
B. The serves are periodical/ going offline and rejecting the connection.
C. The default route in the user's computer points to the wrong upstream device.
D. The IPS system is flagging the traffic as suspicious and terminating the connection.
Which of the following would an organization MOST likely have employees sign before granting access to confidential data?
A. An AUP
B. A BYOD policy
C. An NDA
D. A PUA
A network administrator is configuring a link-state routing protocol for traffic. Which of the following routing protocols should be implemented?
A. BGP
B. EIGRP
C. OSPF
D. RIPv2
A network administrator is looking for an out-of-band method for accessing the console ports of a company's network devices when working remotely. Which of the following can be deployed as a solution?
A. A hub
B. Abridge
C. A modem
D. A WAP
A technician recently installed a new wireless access point for a SOHO with the latest wireless technologies After the installation users with older laptops report their laptops no longer show the wireless network SSID, whereas users with newer equipment do not have this issue. Which of the following is MOST likely the cause?
A. The passphrase was changed
B. The wireless cards do not support 802 11ac.
C. The security type has been upgraded to WPA2
D. The administrator is not broadcasting the SSID
A new employee is unable to access any network resources. All other users are able to access the network at 100Mbps No IP address, subnet mask or default gateway is displayed on the new employee's workstation The network administrator determinates all connectors using the correct standard Upon further investigation the network administrator also notices the following.
Wire map results from the user patch cable lo the patch cable connecting to the switch:
1.
Pins 5 and 7 are short
2.
The distance is 200ft (61m) Additional observations on the switch
1.
The VLAN is set correctly
2.
The port is not disabled
3.
The duplex";speed settings are correct
4.
Port LEOs are off for that port.
5.
The port is set to untagged.
Which of the following is the MOST likely reason the new employee is having network issues?
A. Bad switchport
B. Incorrect pinout
C. Open/short
D. VLAN mismatch
E. Distance limitation
A company has a DNS record for the following address: products companyXYZ. com. The company would like to add another record, sales. companyXYZ. com, which continually points to the same IP address as products companyXYZ.
com.
Which of the following DNS record would BEST accomplish this?
A. MX
B. CNAME
C. SRV
D. A
E. AAAA
F. PTR
Which of the following BEST explains why a network engineer would use a wireless mesh network when connecting sensors to a sensor gateway?
A. It creates various paths to a particular destination
B. It increases the overall throughput of the links connecting the devices
C. It provides redundancy if the sensor network experiences broad wireless interference
D. It allows autonomous communication if the sensor network goes down
A customer has asked a technician to upgrade the wireless router to the fastest speed possible. The technician performs a site survey and notices several older devices will not be able to connect to router that operates In the 5GHz range. Which of the following options should the technician suggest to the customer?
A. 802. 11a
B. 802. 11ac
C. 802. 11b
D. 802. 11n
Nowadays, the certification exams become more and more important and required by more and more enterprises when applying for a job. But how to prepare for the exam effectively? How to prepare for the exam in a short time with less efforts? How to get a ideal result and how to find the most reliable resources? Here on Vcedump.com, you will find all the answers. Vcedump.com provide not only CompTIA exam questions, answers and explanations but also complete assistance on your exam preparation and certification application. If you are confused on your N10-008 exam preparations and CompTIA certification application, do not hesitate to visit our Vcedump.com to find your solutions here.