CompTIA CompTIA Certifications N10-007 Questions & Answers

• Question 421:

  A network administrator needs to access a remote site and log into the site switch using secure methods. The administrator first has to gain access to the server GUI. Which of the following access control methods will be used?

  A. RDP

  B. VPN

  C. Telnet

  D. SSH

  Correct Answer: A

• Question 422:

  A wireless network is set up in a mesh configuration that has experienced recent growth. Some of the access points are four hops away in the mesh network. Users at these access points are reporting slow download speeds despite being the sole users on the access point. Which of the following would BEST resolve this issue?

  A. Add more access points to the mesh network.

  B. Increase transmit power levels on the access points.

  C. Physically connect more access points.

  D. Change the antenna type on the WAPs.

  Correct Answer: C

• Question 423:

  A company has a DNS record for the following address: products.companyXYZ.com. The company would like to add another record, sales.companyXYZ.com, which continually points to the same IP address as products.companyXYZ.com. Which of the following DNS record types would BEST accomplish this?

  A. MX

  B. CNAME

  C. SRV

  D. A

  E. AAAA

  F. PTR

  Correct Answer: B

• Question 424:

  Which of the following devices will intelligently attempt to relieve the network of an assumed threat after sampling a packet stream?

  A. IDS

  B. Content filter

  C. Firewall

  D. IPS

  Correct Answer: D

• Question 425:

  The lack of which of the following components might make a virtual router less efficient than a physical router?

  A. ASIC

  B. Hardware MAC

  C. Jumbo frame

  D. MPLS

  Correct Answer: A

• Question 426:

  A user is reporting poor network performance. A network technician starts by looking at port statistics on that user's connected switchport. The technician notices there is a high level of collisions on the port. Which of the following is the MOST likely cause?

  A. The port or user's NIC is set to auto-MDIX.

  B. The port and/or user's NIC is set to half-duplex.

  C. The port and/or user's NIC is set to the wrong MTU.

  D. The port and user's NIC are set to different speeds.

  Correct Answer: B

• Question 427:

  Which of the following is a purpose of a syslog server?

  A. Aggregates switch logs for easier review and correlation

  B. Polls SNMP-enabled server logs for current status

  C. Distributes logging applications to monitoring servers

  D. Purges switch logs when they reach capacity

  Correct Answer: A

• Question 428:

  A network technician is asked to perform an unfamiliar task. Which of the following would the technician MOST likely reference?

  A. Network configuration

  B. Change management documentation

  C. Work instructions

  D. Performance baseline

  Correct Answer: C

• Question 429:

  A network manager is drafting a document that outlines what employees can and cannot do when using personal tablets that are connected to the network. Which of the following is the manager drafting?

  A. An AUP policy

  B. A BYOD policy

  C. A DLP policy

  D. An NDA policy

  Correct Answer: B

• Question 430:

  A VoIP device is not getting power at a new user's desk. The technician tests the components with a PoE injector at the switch and resolves the issue. Which of the following is the MOST likely cause of the issue?

  A. VLAN mismatch

  B. Bad switchport

  C. TX/RX reverse

  D. Latency

  E. Damaged cable

  Correct Answer: E