CompTIA N10-006 Online Practice Questions and Exam Preparation

CompTIA N10-006 Online Questions & Answers

• Question 911:

  Which of the following are standard fiber cable connector types? (Select TWO).

  A. RJ-11
  B. F-connector
  C. MTRJ
  D. DB-9
  E. ST
  C. MTRJ
  E. ST

• Question 912:

  A network technician needs to install an additional access point to the company's wireless network. The network has two 802.11b access points. Which of the following channels should be used to allow the access point's coverage areas to overlap?

  A. 1, 6, 11
  B. 2, 5, 10
  C. 3, 13, 23
  D. 4, 8, 16
  A. 1, 6, 11

• Question 913:

  After deploying a network switch, the network administrator is unable to remotely administer the device. The network administrator notices that the switch has the following configuration. Which of the following is the MOST likely cause of this issue? Management LAN: 192.168.10.0/24 Management interfacE. 192.168.10.2 255.255.255.0 Default gateway: 192.168.11.1 STP is enabled

  A. VLAN assignment
  B. Wrong subnet mask
  C. Switching loop
  D. Wrong gateway
  D. Wrong gateway

• Question 914:

  Ann, a network technician, was asked to remove a virus. Issues were found several levels deep within the directory structure. To ensure the virus has not infected the .mp4 files in the directory, she views one of the files and believes it contains illegal material. Which of the following forensics actions should Ann perform?

  A. Erase the files created by the virus
  B. Stop and escalate to the proper authorities
  C. Check the remaining directories for more .mp4 files
  D. Copy the information to a network drive to preserve the evidence
  B. Stop and escalate to the proper authorities

  ---

  Computer forensics is about legal evidence found in computers and digital storage. A plan should includefirst responders securing the area and then escalating to senior management and authorities when required by policy or law.

• Question 915:

  A company would like to use the enterprise RADIUS server to authenticate and identify their secure wireless users. Which of the following standards should the company use to facilitate this?

  A. Stateful inspection
  B. WEP
  C. WPA
  D. Open with EAP
  C. WPA

• Question 916:

  Users at a remote site are unable to establish a VPN to the main office. At which of the following layers of the OSI model does the problem MOST likely reside?

  A. Presentation
  B. Application
  C. Physical
  D. Session
  D. Session

• Question 917:

  Which of the following subnet masks would allow for 192.168.0.3 and 192.168.0.240 to be in the same subnet?

  A. 255.255.255.0
  B. 255 255.255.128
  C. 255.255.255.192
  D. 255.255.255.248
  A. 255.255.255.0

• Question 918:

  An organization is upgrading the operating system on several servers and wants to keep legacy input devices. Which of the following needs to be verified before the upgrade to ensure the input devices will be supported after the upgrade?

  A. Driver updates
  B. Virtual terminals
  C. Firmware updates
  D. IP address assignments
  A. Driver updates

• Question 919:

  After upgrading a fiber link from 1Gbps, a network technician ran a speed test of the link. The test shows the link is not operating at full speed and connectivity is intermittent. The two buildings are 1.476ft (450m) apart and are connected using CM4 fiber and 10G SR SFPs. The fiber runs through the electrical and boiler rooms of each building. Which of the following is the MOST likely reason for the connectivity issue?

  A. The wrong SFPs are being used
  B. There is interference from the electrical room.
  C. CM1 fiber should be used instead
  D. There is heat from the boiler room
  A. The wrong SFPs are being used

  ---

  Explanation Explanation/Reference:http://www.cisco.com/c/en/us/products/collateral/interfaces-modules/transceiver-modules/data_sheet_c78-455693.html

• Question 920:

  A user reports that they are unable to access a new server but are able to access all other network resources. Based on the following firewall rules and network information, which of the following ACL entries is the cause?

  User's IP: 192.168.5.14 Server IP: 192.168.5.17 Firewall rules: Permit 192.168.5.16/28 192.168.5.0/28 Permit 192.168.5.0/24192.168.4.0/24 Permit 192.168.4.0/24192.168.5.0/24 Deny 192.168.5.0/28 192.168.5.16/28 Deny 192.168.14.0/24192.168.5.16/28 Deny 192.168.0.0/24 192.168.5.0/24

  A. Deny 192.168.0.0/24 192.168.5.0/24
  B. Deny 192.168.5.0/28 192.168.5.16/28
  C. Deny 192.168.14.0/24 192.168.5.16/28
  D. Implicit Deny rule
  B. Deny 192.168.5.0/28 192.168.5.16/28