CompTIA N10-006 Online Practice Questions and Exam Preparation

CompTIA N10-006 Online Questions & Answers

• Question 471:

  Which of the following solutions will detect and disable a rogue access point?

  A. Port scan
  B. Packet sniffer
  C. IPS
  D. IDS
  C. IPS

• Question 472:

  An employee wishes to use a personal cell phones for work- related purposes, including storage of sensitive company data, during long business trips. Which of the following is needed to protect BOTH the employee and the company?

  A. An NDA ensuring work data stored on the personal phone remains confidential
  B. An AUP covering how a personal phone may be used for work matters
  C. A consent to monitoring policy covering company audits of the personal phone
  D. Real-time remote monitoring of the phone's activity and usage
  D. Real-time remote monitoring of the phone's activity and usage

• Question 473:

  A patch panel was recently installed in a new IDF. The technician was reviewing the ports on the patch panel, and though they looked correct, they were too small to receive patch cables with RJ-45 connectors. Which of the following types of connectors should be used on this patch panel?

  A. RJ-11
  B. RJ-48C
  C. RS-232
  D. DB-25
  A. RJ-11

• Question 474:

  Which of the following commands displays the routing table on a server or workstation?

  A. nbtstat
  B. route
  C. traceroute
  D. nmap
  B. route

  ---

  Explanation Explanation/Reference:The route command allows you to make manual entries into the network routing tables. The route command distinguishes between routes to hosts ...

• Question 475:

  Which of the following describes blocking traffic based upon the Layer 3 sources address of the traffic?

  A. Port filtering
  B. IP filtering
  C. MAC filtering
  D. Application filtering
  B. IP filtering

• Question 476:

  A technician is troubleshooting a problem where data packets are being corrupted. Which of the following connectivity problems should the technician check?

  A. Attenuation
  B. Latency
  C. Crosstalk
  D. External interference
  C. Crosstalk

• Question 477:

  Which of the following cables supports 10Gbps throughput and 100 meters as the maximum distance?

  A. T1 crossover
  B. Singlemode fiber
  C. CAT6a
  D. Coaxial
  C. CAT6a

• Question 478:

  Which of the following WAN technologies has the HIGHEST latency?

  A. ADSL
  B. LTE
  C. Satellite
  D. WiMAX
  C. Satellite

  ---

  Satellite WAN latency is the delay caused by the physical distance a signal must travel from earth, to the satellite, and back to earth to complete a round-trip transmission. Because of the physics involved in the round-trip-time (RTT), end-toend latency can take 600 milliseconds or more due to geosynchronous satellites orbiting miles above the earth.

• Question 479:

  A technician installs three new switches to a company's infrastructure. The network technician notices that all the switch port lights on the front of each switch flashes rapidly when powered on and connected. Additionally, there are rapid flashing amber lights on the switches when they started up the next day.

  Which of the following describes what is occurring with the switches?

  A. The switches are running through their spanning tree process.
  B. The switches are having problems communicating with each other.
  C. The switches are connected and detected a spanning tree loop.
  D. The switches are not functioning properly and need to be disconnected.
  A. The switches are running through their spanning tree process.

• Question 480:

  A technician notices that network access is becoming increasingly slow. All of the activity lights, on the only network layer 2 switch, are blinking at steadily increasing rates. Which of the following is the MOST likely cause of the increased traffic?

  A. STP blocking
  B. IP addresses
  C. MTU mismatch
  D. Switching loop
  D. Switching loop