CompTIA N10-006 Online Practice Questions and Exam Preparation

CompTIA N10-006 Online Questions & Answers

• Question 191:

  Which of the following connectors is used for coaxial copper cable?

  A. BNC
  B. DB-9
  C. RJ-11
  D. ST
  A. BNC

• Question 192:

  Kim, a technician, is installing a switch that does not feature auto-negotiation. Which of the following characteristics would need to be manually configured? (Select TWO).

  A. MAC addressing
  B. IP addressing
  C. Port speed
  D. IPv6 addressing
  E. Duplex
  C. Port speed
  E. Duplex

• Question 193:

  A user is having trouble with their fax machine disconnecting during transmissions. The technician believes that a DSL signal may be on the same line as the fax. Which of the following tools would MOST likely help prove this hypothesis?

  A. Multimeter
  B. Cable tester
  C. Lineman's handset
  D. Toner probe
  C. Lineman's handset

• Question 194:

  A user is unable to open up websites on the Internet from a browser. The administrator determines that the workstation can ping its local gateway, but not the remote web server. At which of the following layers of the OSI model does the problem MOST likely exist?

  A. Data link
  B. Network
  C. Session D. Physical
  B. Network

• Question 195:

  A small office home office (SOHO) customer is going to be replacing their switch. The customer also wants to add a WAP in a dropped ceiling; however, there are no power outlets above the drop ceiling, but there is a CAT5e network jack. Which of the following technologies should the new switch have to allow this WAP to be placed where the customer requests, without any other major changes to the environment?

  A. PoE
  B. Layer 3 switching
  C. STP
  D. VLAN
  A. PoE

• Question 196:

  A technician is being tasked to centralize the management of the switches and segment the switches by broadcast domains. The company is currently all on VLAN1 using a single private IP address range with a 24 bit mask. The supervisor wants VLAN 100 to be the management subnet and all switches to share the VLAN information. Which of the following options would work BEST to accomplish these requirements?

  A. Use VLSM on the IP address range, with STP and 802.1q on the inter switch connections with native VLAN 100
  B. Use VLSM on the IP address range with VTP and 802.1x on all inter switch connections with native VLAN 100
  C. Use VLSM on VLAN1, with VTP and 802.1w on the inter switch connections with native VLAN 100
  D. Use VLSM on the IP address range with VTP and 802.1q on the inter switch connections with native VLAN 100
  D. Use VLSM on the IP address range with VTP and 802.1q on the inter switch connections with native VLAN 100

• Question 197:

  A technician is troubleshooting Internet connectivity for a PC. Which of the following is MOST likely the reason for Internet connectivity issues upon inspecting the routing table?

  

  A. The router should be listed as 224.0.0.1
  B. The NIC is set to the wrong subnet mask
  C. The route of last resort is missing
  D. Loopback traffic is weighted higher than NIC interface traffic
  C. The route of last resort is missing

  ---

  The default route is missing from the table. It looks like this: Network Destination Netmask Gateway Interface Metric 0.0.0.0 0.0.0.0 192.168.1.1 192.168.1.12 25

• Question 198:

  Which of the following is used to describe trunking VLANs on a network?

  A. 802.11a
  B. 802.11i
  C. 802.1q
  D. 802.1x
  C. 802.1q

• Question 199:

  A technician has traced a POTS line to a 110 block. Which of the following devices would the technician MOST likely use to see if the line carries a dial tone?

  A. Toner Probe
  B. Punch Down Tool
  C. Protocol Analyzer
  D. Butt Set
  D. Butt Set

• Question 200:

  Which of the following protocols is used to provide secure authentication and encryption over non-secure networks?

  A. RADIUS
  B. TLS
  C. PPTP
  D. HTTP
  B. TLS