CompTIA N10-006 Online Practice Questions and Exam Preparation

CompTIA N10-006 Online Questions & Answers

• Question 1461:

  Which of the following can MOST likely cause intermittent connection problems with a CAT5 network cable?

  A. Cable has been looped too many times.
  B. Cable has a twist tie attached too close to the connector.
  C. Cable is too warm.
  D. Cable is run too close to a fluorescent light.
  D. Cable is run too close to a fluorescent light.

  ---

  Cat 5 is a twisted pair cable for carrying signals. This type of cable is used in structured cabling for computer networks such as Ethernet. The cable standard provides performance of up to 100 MHz and is suitable for 10BASE-T, 100BASE-TX (Fast Ethernet), and 1000BASE-T (Gigabit Ethernet).

• Question 1462:

  A network administrator is implementing a wireless honeypot to detect wireless breach attempts. The honeypot must implement weak encryption to lure malicious users into easily breaking into the network. Which of the following should the network administrator implement on the WAP?

  A. WPA
  B. WPA2
  C. WEP
  D. VPN
  C. WEP

  ---

  Explanation Explanation/Reference:Wired Equivalent Privacy (WEP) is a security algorithm for IEEE 802.11 wireless networks. Introduced as part of the original 802.11 standard ratified in September 1999, its intention was to provide data confidentiality comparable to that of a traditional wired network.WEP, recognizable by the key of 10 or 26 hexadecimal digits, is widely in use and is often the first security choice presented to users by router configuration tools

• Question 1463:

  A small business owner is in the process of setting up a SOHO office. The office has only one connection to the Internet via a broadband cable connection. The office has four subnets that must be able to connect to the Internet. Which of the following devices would enable the owner to meet these requirements?

  A. A firewall
  B. A router
  C. A hub
  D. A Layer 2 switch
  B. A router

• Question 1464:

  A technician has to terminate a CAT3 cable to a 110 block. Which of the following tools should the technician use?

  A. Loopback plug
  B. Multimeter
  C. Punch down
  D. Crimper
  C. Punch down

• Question 1465:

  A unified communication system has a requirement to eliminate POTS-dependent equipment. Which of the following MUST be specifically addressed in the proposed solution?

  A. FAX integration
  B. UC gateway vendor
  C. COS implementation
  D. Telepresence
  E. UC server configuration
  A. FAX integration

• Question 1466:

  While working on a PC, a technician notices 0.0.0.0 in the routing table. Which of the following does this indicate?

  A. It is the default route.
  B. This is the address for the DHCP server.
  C. The PC has not been assigned an IP address.
  D. The firewall is down.
  A. It is the default route.

  ---

  Explanation Explanation/Reference:The address 0.0.0.0 generally means "any address". If a packet destination doesn't match an individual address in the table, it must match a 0.0.0.0 gateway address. In other words, default gateway is always pointed by 0.0.0.0:

• Question 1467:

  Which of the following access controls enforces permissions based on data labeling at specific levels?

  A. Mandatory access control
  B. Separation of duties access control
  C. Discretionary access control
  D. Role based access control
  A. Mandatory access control

• Question 1468:

  The ability to make access decisions based on an examination of Windows registry settings, antivirus software, and AD membership status is an example of which of the following NAC features?

  A. Quarantine network
  B. Persistent agents
  C. Posture assessment
  D. Non-persistent agents
  C. Posture assessment

  ---

  Network Admission Control (NAC) can permit or deny access to anetwork based on characteristics of the device seeking admission, rather than just checking user credentials. For example, a client's OS, Windows Registry settings, AD membership status, and version of antivirus software could be checked against a set of requirements before allowing the client to access a network. This process of checking a client's characteristics is called posture assessment.

• Question 1469:

  A technician discovers that a malware infection has damaged part of the Windows TCP/IP stack. Which of the following commands can help repair the damage?

  A. netsh lan
  B. netsh interface
  C. netsh wlan
  D. netsh winsock
  D. netsh winsock

• Question 1470:

  A technician is troubleshooting a network camera. The technician restarted the modem and now the camera is no longer available from a mobile device. Which of the following has MOST likely occurred?

  A. The public IP address of the network has changed.
  B. The camera has received a new firmware update.
  C. The camera's secure shell has been disabled.
  D. The router has changed the IP of the mobile device.
  A. The public IP address of the network has changed.