CompTIA N10-006 Online Practice Questions and Exam Preparation

CompTIA N10-006 Online Questions & Answers

• Question 991:

  Which of the following is a connectionless protocol? (Select TWO)

  A. ICMP
  B. SSL
  C. TCP
  D. SSH
  E. HTTP
  F. UDP
  A. ICMP
  F. UDP

• Question 992:

  Which of the following network devices restricts traffic based on words, signatures, and URLs?

  A. Layer 2 switch
  B. Content filter
  C. Load balancer
  D. Traffic analyzer
  B. Content filter

• Question 993:

  A network technician has been asked to add a user to an administrative group on the network.

  Which of the following change management procedures should be followed?

  A. Network configuration
  B. Potential impact analysis
  C. Rollback process
  D. Approval process
  D. Approval process

• Question 994:

  A network technician is performing a wireless survey in the office and discovers a device that was not installed by the networking team. This is an example of which of following threats?

  A. Bluesnarfing
  B. DDoS
  C. Brute force
  D. Rogue AP
  D. Rogue AP

  ---

  A rogue access point is when a wireless access point is located on a network without the administrator being awareof it. Therefore, if the device was not installed by the networking team, the administrator would not know about it being there.

• Question 995:

  A network technician is trying to terminate CAT5 modular jacks. Which of the following tools would be MOST appropriate for this scenario?

  A. Crimper
  B. OTDR
  C. Throughput tester
  D. Punch down tool
  D. Punch down tool

• Question 996:

  A technician needs to make a web server with a private IP address reachable from the Internet. Which of the following should the technician implement on the company firewall?

  A. DOCSIS
  B. NAT
  C. CIDR
  D. VPN
  B. NAT

• Question 997:

  You have been tasked with testing a CAT5e cable. A summary of the test results can be found on the screen.

  Step 1: Select the tool that was used to create the cable test results.

  Step 2: Interpret the test results and select the option that explains the results. After you are done with your analysis, click the 'Submit Cable Test Analysis' button.

  

  

  Correct Answer. Check the answer below:
  Check the answer below:

  ---

  A Cable Certifier provides “Pass” or “Fail” information in accordance with industry standards but can also show detailed information when a “Fail” occurs. This includesshorts, the wire pairs involved and the distance to the short. When a short is identified, at the full length of the cable it means the cable has not been crimped correctly.

  

• Question 998:

  A training class is being held in an auditorium. Hard-wired connections are required for all laptops that will be used. The network technician must add a switch to the room through which the laptops will connect for full network access. Which of the following must the technician configure on a switch port, for both switches, in order to create this setup?

  A. DHCP
  B. Split horizon
  C. CIDR
  D. TRUNK
  D. TRUNK

  ---

  We should use trunk ports to set up a VLAN for the laptops that will be used in the auditorium. A trunk portis a port that is assigned to carry traffic for all the VLANs that are accessible by a specific switch, a process known as trunking. Trunk ports mark frames with unique identifying tags ?either 802.1Q tags or Interswitch Link (ISL) tags ?as they move between switches. Therefore, every single frame can be directed to its designated VLAN.

• Question 999:

  Which of the following wireless standards provide speed of 11Mbps?

  A. 802.11a
  B. 802.11b
  C. 802.11g
  D. 802.11n
  B. 802.11b

  ---

  802.11a - 54Mbps - OFDM 802.11b - 11Mbps - DSSS 802.11g - 54Mbps - OFDM/DSSS 802.11n - 150/300Mbps (MIMO) OFDM

• Question 1000:

  Which of the following wireless standards has a maximum rate of less than 50 Mbps?

  A. 802.11a
  B. 802.11b
  C. 802.11g
  D. 802.11n
  B. 802.11b