HP HPE6-A44 Online Practice Questions and Exam Preparation

HP HPE6-A44 Online Questions & Answers

• Question 81:

  A customer uses an SIP application that is not supported by Aruba United Communications and Collaboration (UCC). Which voice deployment mode should the administrator implement on Aruba Mobility Controllers (MCs) to support this application?

  A. Heuristic mode
  B. SDN-API mode
  C. QoS-mode
  D. WMM-only mode
  A. Heuristic mode

• Question 82:

  What must the administrator configure on AirWare to monitor and run operational commands on the Aruba Mobility Masters (MMs) and Mobility Controllers (MCs)?

  A. PAPI and SSH/telnet
  B. PAPI and SNMP
  C. SNMP and HTTPS
  D. SNMP and SSH/telnet
  D. SNMP and SSH/telnet

• Question 83:

  An administrator purchases a RAP and has it shipped directly to a branch office. The branch office plugs in the RAP and the RAP contacts Aruba Activate. The RAP learns the Mobility Controller (MC) IP address and connects to it. However,

  the connection fails.

  Upon verifying the MC IP address in Aruba Activate, what should the administrator do to allow the RAP connection to succeed?

  A. Whitelist the RAP's IP address on the MC.
  B. Define the RAP's IPSec pre-shared key in Activate.
  C. Whitelist the RAP's certificate on the MC.
  D. Configure a VPN address pool in Activate.
  A. Whitelist the RAP's IP address on the MC.

• Question 84:

  An administrator wants to implement the MultiZone feature in a company's network to segregate corporate and guest traffic. Corporate traffic will have APs establish connections to a cluster managed by a Mobility Master (MM), and guest traffic will have the same APs establish connections to a standalone controller at the company's DMZ.

  What is true about the implementation of MultiZones in this scenario?

  A. The MultiZone feature must be enabled in the data zone.
  B. The primary zone maintains full control of AP management and configuration.
  C. The primary and data zones must be in the same L2 subnet.
  D. A MultiZone AP can initially connect to any zone to obtain its configuration.
  A. The MultiZone feature must be enabled in the data zone.

• Question 85:

  Refer to the exhibit. What can the administrator determine from the configuration shown in the exhibit?

  

  A. All the controllers run in standalone mode.
  B. MM2 is the Mobility Master.
  C. VRRP is used for Mobility Master redundancy.
  D. All the controllers run in a cluster.
  B. MM2 is the Mobility Master.

• Question 86:

  Refer to the exhibit.

  

  An administrator configures a split-tunnel policy to be used by RAPs at branch offices, Under the Configuration section on the Mobility master (MM) shown in the exhibit, where should the administrator configure the split-tunnel mode so that it can be deployed to the RAPs?

  A. WLAN
  B. Roles and Policies
  C. Access Points
  D. Services
  C. Access Points

• Question 87:

  An administrator enables AP load balancing for a cluster of Mobility Controllers (MCs). APs connected to the cluster have an LMS IP address configured in their AP Group configuration. No other parameters are changed in the cluster. If the two load AP thresholds are reached, what occurs?

  A. The APs are rebalanced across the cluster.
  B. The APs always stay connected to the LMS IP address configured in the AP Group profile.
  C. The users are rebalanced across the cluster.
  D. The users and APs are rebalanced across the cluster.
  A. The APs are rebalanced across the cluster.

• Question 88:

  Which ArubaOS CLI command can an administrator execute to determine if AP load balancing is enabled in a cluster?

  A. show aaa cluster essid
  B. show lc-cluster group-membership
  C. show switches
  D. show ap active
  B. show lc-cluster group-membership

• Question 89:

  An administrator stages an AP and re-provisions it as a RAP from the Mobility Master (MM). When re-provisioning the RAP, the administrator must enter a user's credentials. What is the purpose of these credentials?

  A. to authenticate users on wired and wireless ports
  B. to authenticate the RAP device
  C. to authenticate users on wireless ports
  D. to authenticate users on wired ports
  B. to authenticate the RAP device

• Question 90:

  An administrator needs to support Unified Communications and Collaboration (UCC) in a company's network. The network infrastructure requires the OpenFlow protocol to support SDN-capable applications. Which controller topology meets these requirements?

  A. Zones
  B. Standalone Mobility Controller
  C. Mobility Master-Mobility Controller
  D. Master_Local
  B. Standalone Mobility Controller