HP HP2-K39 Online Practice Questions and Exam Preparation

HP HP2-K39 Online Questions & Answers

• Question 31:

  In an HP StoreOnce 6500 Backup system unit, how many hot spares are there per D6000 drawer?

  B. 1
  C. 2
  D. 4
  D. 4

• Question 32:

  Your customer has data security requirements. Which features provided by the HP StoreOnce Security Package will help the customer meet this requirement? (Select two.)

  A. Secure Erase
  B. in-flight backup encryption
  C. secure host presentation
  D. data-at-rest encryption
  E. Encryption Key Management
  A. Secure Erase
  D. data-at-rest encryption

• Question 33:

  On an HP StoreOnce Multi-node Backup system, what must be done before performing a firmware upgrade on the P1228 RAID controller?

  A. Disable failover.
  B. Shut down service sets.
  C. Perform a manual failover to the other node.
  D. Shut down the other node.
  B. Shut down service sets.

• Question 34:

  Your customer wants to add their HP StoreOnce Backup device to an Active Directory domain. How can this task be completed?

  A. from the StoreOnce WMI, from the NAS menu tree
  B. from the CLI, using the system add security command
  C. from the StoreOnce WMI, from the Catalyst menu tree
  D. from the CLI, using the system set config command
  D. from the CLI, using the system set config command

• Question 35:

  Which recommendations should be followed when zoning an HP StoreOnce 6500 Backup system into a large fabric?

  A. Target-centric zoning should be used, combining tape and disk targets into single zones.
  B. Host-centric zoning should be used, splitting tape and disk targets into different zones.
  C. No zoning should be used; it is not required for the HP StoreOnce 6500 Backup system.
  D. The highest port on the SAN switch should be zoned for the tape controller.
  B. Host-centric zoning should be used, splitting tape and disk targets into different zones.

• Question 36:

  Which HP resource can be used to obtain the HP StoreOnce Enterprise Manager?

  A. HP Support Center
  B. HP PartnerOne or Smart Portal
  C. HP Software Depot Home
  D. HP StoreOnce Product Page
  C. HP Software Depot Home

• Question 37:

  Your customer has a requirement for trending and alerting information of their HP StoreOnce Backup system. How can your customer perform this function?

  A. Install StoreOnce Enterprise Manager
  B. Configure SNMP alerting.
  C. Install HP OneView.
  D. Configure reporting within the StoreOnce GUI.
  A. Install StoreOnce Enterprise Manager

• Question 38:

  When configuring an HP StoreOnce 4900 Backup system, your customer requires a fault tolerant network bond due to their network restrictions. Which bonding mode would best fit this situation?

  A. Mode 1 (Active-Backup)
  B. Mode 3 (Active-Passive)
  C. Mode4 (LACP)
  D. Mode 6 (Balance-ALB)
  B. Mode 3 (Active-Passive)

• Question 39:

  Where does the failover in an HP StoreOnce 6500 Backup system take place?

  A. within a storage unit
  B. within a service set
  C. within a couplet
  D. within a cluster
  C. within a couplet

• Question 40:

  You need to configure the network for an HPStoreOnce 6500 Backup system with FW Rev. 3.10.0 on two couplets and plan to implement template two. How many IP addresses are used to implement network template two?

  A. two virtual management IP addresses and eight for data (6P + 4V)
  B. four virtual data IP addresses (3V+ 1P) and five management IP addresses (4P + 1V)
  C. five management IP addresses (4P + 1V) and eight for data (4P + 4V)
  D. one management IP (1V) and eight IP addresses for data (4P + 4V)
  D. one management IP (1V) and eight IP addresses for data (4P + 4V)