Huawei HC-224 Online Practice Questions and Exam Preparation

Huawei HC-224 Online Questions & Answers

• Question 371:

  The value of ospfdr-priority ranges from 0 to 255 and the default value is 64.

  A. True
  B. False
  B. False

• Question 372:

  By using VRRP, the backup router in a VRRP backup group immediately becomes the master router after detecting a fault and instructs its attached hosts to perform a master/slave switchover accordingly. This ensures that services will recover within a short period of time.

  A. True
  B. False
  B. False

• Question 373:

  On a non-broadcast network, OSPF has two operating modes: NBMA and P2MP.

  A. True
  B. False
  A. True

• Question 374:

  By which can an IP-based advanced ACL filter packets? (Select 5 Answers)

  A. Source IP address and its subnet mask
  B. Destination IP address and its subnet mask
  C. Protocol type
  D. TCP or UDP port number
  E. Priority of the data packet
  F. Length of the data packet
  A. Source IP address and its subnet mask
  B. Destination IP address and its subnet mask
  C. Protocol type
  D. TCP or UDP port number
  E. Priority of the data packet

• Question 375:

  Which of the following statements about RSTP and STP is true?

  A. STP has more port states than RSTP.
  B. The port roles used in RSTP is less than the port roles used in STP.
  C. Since RSTP adopts fast convergence mechanism, it does not have Learning state which is available in STP.
  D. Same as STP, the ports will enter into Listening state once the RSTP has been enabled. Then, the ports can receive BPDU and calculate the spanning tree.
  A. STP has more port states than RSTP.

• Question 376:

  The dot1x command is used to enable 802.1x authentication globally or on an interface. Which statements about the undo dot1x command are true? (Select 3 Answers)

  A. It is used to disable 802.1x authentication globally.
  B. It will disconnect online users from the interface; therefore, use the command with caution.
  C. It is used to disable 802.1x authentication on an interface.
  D. Ensure that there are no online users before you run the undo dot1x command. Otherwise, running the undo dot1x command fails.
  A. It is used to disable 802.1x authentication globally.
  C. It is used to disable 802.1x authentication on an interface.
  D. Ensure that there are no online users before you run the undo dot1x command. Otherwise, running the undo dot1x command fails.

• Question 377:

  Which LSA is used by OSPF to implement GR?

  A. Type-3 LSA
  B. Type-5 LSA
  C. Type-9 LSA
  D. Type-10 LSA
  C. Type-9 LSA

• Question 378:

  Which of the following routers have multicast routing entries even when there is no receiver on the network? (Select 2 Answers)

  A. Source's DR
  B. Receiver router
  C. Intermediate router
  D. RP
  A. Source's DR
  D. RP

• Question 379:

  A device can be assigned an IP address 192.168.13.175, with the mask being 255.255.255.240.

  A. True
  B. False
  B. False

• Question 380:

  In the VRP, by default, the routes imported by BGP are not automatically summarized.

  A. True
  B. False
  A. True