Huawei H31-211 Online Practice Questions and Exam Preparation

Huawei H31-211 Online Questions & Answers

• Question 151:

  In the default state of Huawei routers, what is the priority of common routing protocols, from high to low?

  A. direct > OSPF >ISIS >RIP
  B. OSPF >ISIS >RIP >direct
  C. RIP >ISIS >OSPF >direct
  D. direct >ISIS >OSPF >RIP
  A. direct > OSPF >ISIS >RIP

• Question 152:

  Which method of authentication is supported in the RIPv1 seal text?

  A. Clear text
  B. Ciphertext
  C. MD5 ciphertext verification
  D. Does not support authentication
  D. Does not support authentication

• Question 153:

  What are the duplex modes supported by the Ethernet electrical port? (multiple choice)

  A. Full duplex
  B. Half duplex
  C. Simplex
  D. Auto-negotiation
  A. Full duplex
  B. Half duplex
  D. Auto-negotiation

• Question 154:

  Which of the following statements about OSPF are correct? (multiple choice)

  A. Support for classless inter-domain routing CIDR
  B. Using distance vector algorithm
  C. Use triggered update, if the network topology changes, send update packets immediately, and synchronize this change in the autonomous system D. Supports sending protocol packets by multicast address
  A. Support for classless inter-domain routing CIDR
  C. Use triggered update, if the network topology changes, send update packets immediately, and synchronize this change in the autonomous system D. Supports sending protocol packets by multicast address

• Question 155:

  Which of the following TCP/IP models does the G.703 standard related to the WAN belong to?

  A. Physical layer
  B. Data link layer
  C. Transport layer
  D. Application layer
  A. Physical layer

• Question 156:

  Which parameters must be specified to configure a static MAP in a Frame Relay package? (multiple choice)

  A. Local DLCI
  B. Peer DLCI
  C. Local protocol address
  D. The protocol address of the peer
  A. Local DLCI
  D. The protocol address of the peer

• Question 157:

  Which of the following technologies is used to implement point-to-multipoint data transmission in IPTV?

  A. Unicast
  B. Broadcast
  C. Multicast
  D. Anycast
  C. Multicast

• Question 158:

  Each routing protocol corresponds to a routing priority. What is the priority range?

  A. 1-1024
  B. 0-255
  C. 0-256
  D. 0-1024
  B. 0-255

• Question 159:

  Which of the following fields are included in the routing table? (multiple choice)

  A. Source address
  B. Next hop
  C. Target network
  D. Routing metrics
  B. Next hop
  C. Target network
  D. Routing metrics

• Question 160:

  Fragmentation can occur on the original sender host or on the intermediate router. After sharding an IP datagram, which of the following cases will be reassembled?

  A. When the message is looped back
  B. Next router
  C. Intermediate router
  D. Message destination
  D. Message destination