Huawei H12-261 Online Practice Questions and Exam Preparation

Huawei H12-261 Online Questions & Answers

• Question 431:

  The port shaping rate is set to 100 Mbps PIR, and the bandwidth of the service input and configuration of the interface is as follows. Then the first round of rotation, the assigned team What is the bandwidth?

  

  A. 30M
  B. 15M
  C. 90M
  D. 25M
  B. 15M

• Question 432:

  LAND's attack means that the attacker sends a source address and a destination address to the target host. The target is marked as the source port and the destination port. SYN ACK TCP report text, the receiving end is waiting for the sending end of the final message, and the connection is always connected in a semi-connected state, causing the receiver to receive limited resources.Waste

  A. Correct
  B. Error
  B. Error

• Question 433:

  When an ABR is attached to an NSSA and translates from type 7 to type 5 LSA, it can aggregate the type 5 LSAs which are converted from type 7 LSAs.

  A. True
  B. False
  A. True

• Question 434:

  The following is about the address of the method VPNv4, ? said to describe the error

  A. By default, the PE VPNv4 vpn-target does not filter the route.
  B. VPNv4 12, 8 RD (Route Distinguisher) 4 The IPv4 address has a total of bytes including the route identifier of the word and the section address prefix of the word.
  C. Locally, the routing information from the PE site VPNv4 PE, Target, which is directly related to itself, is sent to the previous routing.
  D. The Build attribute of BGP is distributed with the routing extension.
  E. In the reachable and unreachable BGP VPNv4, the RD carries the attribute when it routes.
  A. By default, the PE VPNv4 vpn-target does not filter the route.

• Question 435:

  The following is about the correct change of the MUX VLAN in Huawei.

  A. Under the same one, you can mix and use VLAN MUX VLAN Super VLAN
  B. MUX VLAN Principal VLAN Subor is divided into and divided into dinate VLANs, Subordinate VLAN S is separate VLAN and Isolate VLAN
  C. Each can be bound to multiple Separate VLAN Principal VLANs
  D. Principal Port MUX VLAN can communicate with all interfaces inside
  D. Principal Port MUX VLAN can communicate with all interfaces inside

• Question 436:

  Existing router R1. R2. R3 R4 4 LAN 4 Router Network of routers and routers. This router is connected to the network through a network. All stations The routers are all deployed with basics. When you command OSPF R2 "display ospf peer"

  on the router line, R2 R3 discovers the router and router.

  The state of the state is "2way", ? Then from the output, what can you draw?

  A. Router is R4 DR
  B. Router Yes or R2 DR BDR
  C. Router is not R2 DR
  D. Router is not R3 DR, BDR
  E. Router and router do not form R2 R3 full adjacency
  C. Router is not R2 DR
  D. Router is not R3 DR, BDR
  E. Router and router do not form R2 R3 full adjacency

• Question 437:

  Which of the following is not included in a digital certificate?

  A. Digital envelope
  B. Issuer
  C. Public key Information
  D. Digital signature
  D. Digital signature

• Question 438:

  About the BGP, the following describes the error

  A. The Alliance divides an AS AS As AS into several parts for the outside of the alliance.
  B. Alliance sub-AS, BGP number tacit notification
  C. The affiliated sub-owner can use the private AS NE/AR, number 32. A Huawei router can be configured with up to a sub-autonomous system.
  D. The joint detection alliance can easily go to the AS, and the path selection factor in As EBGP runs for each other.
  B. Alliance sub-AS, BGP number tacit notification

• Question 439:

  The following topology and configuration are available. The following is correct?

  

  A. There is no route on the destination network segment on R1 10.0.3.3/32.
  B. There is no route on the destination network segment on R1 10.0.2.2/32.
  C. There is a route on the destination network segment on R1 10.0.3.3/32.
  D. There is a route on the destination network segment on R1 10.0.2.2/32.
  A. There is no route on the destination network segment on R1 10.0.3.3/32.
  D. There is a route on the destination network segment on R1 10.0.2.2/32.

• Question 440:

  The fields of the OSPFv3 Option LSA are all present.

  A. Yes
  B. Wrong
  B. Wrong