Huawei H12-224 Online Practice Questions and Exam Preparation

Huawei H12-224 Online Questions & Answers

• Question 491:

  To enable an Eudemon in routing mode to work like a router, you need to assign IP addresses to interfaces and enable dynamic or static routing protocols on the Eudemon.

  A. True
  B. False
  A. True

• Question 492:

  Traffic policing usually uses which of the following QoS technologies?

  A. GTS
  B. LR
  C. CAR
  D. WRED
  C. CAR

• Question 493:

  What is the default priority of the device in a VRRP group?

  A. 200
  B. 150
  C. 100
  C. 100

• Question 494:

  The core of the MPLS technology is label switching.

  A. True
  B. False
  A. True

• Question 495:

  Once a BGP connection is established, if load balancing is not configured, a BGP Speaker just advertises the optimal route in its BGP routing table to its neighbors.

  A. TRUE
  B. FALSE
  A. TRUE

• Question 496:

  The network 154.27.0.0 without any subnet can support() hosts?

  A. 254
  B. 1024
  C. 65,534
  D. 16,777,206
  C. 65,534

• Question 497:

  If a router receives two BGP routes (M and N) that contain the following attributes,

  

  Which route is the optimal route based on BGP route selection rules?

  A. The optimal route is route M because its AS_Path is shorter than that of route N.
  B. The optimal route is route N because its MED value is smaller than that of route M.
  C. The optimal route is determined randomly.
  A. The optimal route is route M because its AS_Path is shorter than that of route N.

• Question 498:

  An IP network can provide various packet forwarding services. Users are concerned about which of the following during packet forwarding? (Choose three.)

  A. Throughput
  B. Delay
  C. Cost
  D. Loss of packet
  A. Throughput
  B. Delay
  D. Loss of packet

• Question 499:

  Which of the following statements regarding the OSPF protocol are true? (Choose all that apply.)

  A. An OSPF topology has three endpoint types: router node, stub network segment, and transit network segment.
  B. A broadcast network segment or a NBMA network segment with at least two routers are a type of transit network segment.
  C. The default bandwidth reference value of OSPF is 100 Mbit/s.
  D. The cost from a transit network segment to the router connected to this network segment is 100.
  A. An OSPF topology has three endpoint types: router node, stub network segment, and transit network segment.
  B. A broadcast network segment or a NBMA network segment with at least two routers are a type of transit network segment.
  C. The default bandwidth reference value of OSPF is 100 Mbit/s.

• Question 500:

  VXLAN is irrelevant to SDN technology.

  A. TRUE
  B. FALSE
  A. TRUE