Huawei Huawei Certifications H12-224 Questions & Answers

• Question 361:

  Which command must be configured to establish a BGP peer relationship between indirectly connected EBGP peers?

  A. Peer connect-interface

  B. Peer valid-ttl-hops

  C. Peer ignore

  D. Peer ebgp-max-hop

  Correct Answer: D

• Question 362:

  Using the peer connect-interface command to establish "multiple" peer relationships between two routers connected through "multiple" links is recommended.

  A. True

  B. False

  Correct Answer: A

• Question 363:

  The Origin attribute of the BGP route that is imported by using the network command is IGP.

  A. True B. False

  Correct Answer: A

• Question 364:

  In the process of calculating SPF tree, the cost from a node to root node equals to metric listed in the Router LSA generated by the node.

  A. True

  B. False

  Correct Answer: B

• Question 365:

  In OSPF protocol, which of the following statements are incorrect regarding Link ID of Router LSA? (Choose two.)

  A. In Point-to-Point link type, Link ID is the neighbor's Interface IP address.

  B. InTransNet link type, Link ID is the network address of TransNet network segment.

  C. InStubNet link type, Link ID is the network address of Stub network.

  D. In Virtual link type, Link ID is the neighbor's Router ID of virtual link.

  Correct Answer: AB

• Question 366:

  What is private AS number?

  A. 65410-65535

  B. 1-64511

  C. 64512-65535

  D. 64511-65535

  Correct Answer: C

• Question 367:

  Which statement about BGP is false?

  A. BGP runs over TCP.

  B. BGP is an enhanced distance-vector routing protocol.

  C. BGP uses port number 189.

  D. BGP is an inter-AS routing protocol.

  Correct Answer: C

• Question 368:

  Assume that the following commands are run to configure BGP:

  

  Which statements about the configurations are true? (Choose two.)

  A. The global configuration is preferred. Therefore, the timer values for peer 1.1.1.2 are "keepalive 30 hold 90."

  B. The peer configuration is preferred. Therefore, the timer values for peer 1.1.1.2 are "keepalive 10 hold 30."

  C. The smaller one between the global and peer timer values is used. Therefore, the timer values of peer

  1.1.1.2 is "keepalive 10 hold 30".

  D. The default configuration is "timer keepalive 60 hold 180." Therefore, peer 1.1.1.2 can detect connection faults faster than the default configuration.

  Correct Answer: BD

• Question 369:

  If the hold timers in the Open messages sent from BGP Peer A and Peer B are 180s and 90s respectively, what is the interval at which Keepalive messages are sent after Peer A and Peer B have established a BGP peer relationship?

  A. 180s

  B. 90s

  C. 60s

  D. 30s

  Correct Answer: D

• Question 370:

  Which TCP port is used by BGP?

  A. 520

  B. 89

  C. 179

  D. 180

  Correct Answer: C