Extreme Networks EW0-200 Online Practice Questions and Exam Preparation

Extreme Networks EW0-200 Online Questions & Answers

• Question 111:

  Extreme Networks switches that use the ?chipset support switching and routing of jumbo frames at wire- speed on all ports.

  A. TRUE
  B. FALSE
  A. TRUE

• Question 112:

  The Extreme switch ASIC look-up Host Table containing IP host routes, outbound VLAN interfaces and ports is called:

  A. IP Route Table
  B. IP ARP Table
  C. IP FDB
  C. IP FDB

• Question 113:

  When multiple VLANs need to be configured on one physical port, all these VLANs must be configured with a tag.

  A. TRUE
  B. FALSE
  B. FALSE

• Question 114:

  In normal IP unicast routing, all forwarding decisions are based on the ______________ of each packet.

  A. destination MAC address
  B. source IP address
  C. source MAC address
  D. destination IP address
  D. destination IP address

• Question 115:

  How long in seconds, is the Extreme switch?FDB Aging time set at by default?

  A. 100
  B. 200
  C. 300
  D. 400
  C. 300

• Question 116:

  What is the proper CLI command syntax to create a user-level account for johndoe?

  A. create user account johndoe
  B. create account user johndoe
  C. create account johndoe user
  D. None of these.
  B. create account user johndoe

• Question 117:

  Which CLI command will you use to change the CLI prompt from the default display to Switch02?

  A. CONFIG SNMP SYSLOCATION Switch02
  B. CONFIG SNMP SYSNAME Switch02
  C. CONFIG CLI PROMPT Switch02
  D. CONFIG CLI DISPLAY Switch02
  B. CONFIG SNMP SYSNAME Switch02

• Question 118:

  You need to add 192.168.0.254 as a trap receiver with a community of SECRET on an Extreme switch. How will you do this?

  A. config snmp 192.168.0.254 trapreceiver add community secret
  B. config snmp add 192.168.0.254 trapreceiver community SECRET
  C. config snmp trapreceiver 192.168.0.254 add community secret
  D. config snmp add trapreceiver 192.168.0.254 community SECRET
  D. config snmp add trapreceiver 192.168.0.254 community SECRET

• Question 119:

  What command would you execute to create a new protocol filter?

  A. Enter the CLI command config protocol vlan .
  B. Enter the CLI command create protocol vlan .
  C. Enter the CLI command create protocol .
  D. Enter the CLI command config protocol .
  C. Enter the CLI command create protocol .

• Question 120:

  Which CLI command will list the ports involved in load sharing and also identifies the master logical port?

  A. show ports all stat
  B. show ports all utilization
  C. show ports all configuration
  D. All of these
  C. show ports all configuration