EMC E20-375 Online Practice Questions and Exam Preparation

EMC E20-375 Online Questions & Answers

• Question 131:

  You are a storage administrator tasked with creating a Consistency Group in a RecoverPoint/EX system. You launch the Protect Volumes wizard in Unisphere and notice that the desired production volume is not available. What would be a possible cause?

  A. The volumes are not masked to the RPAs.
  B. The volumes are masked to a host.
  C. The journal volumes are on a non-licensed array.
  D. Consistency Groups can only be created by boxmgmt.
  A. The volumes are not masked to the RPAs.

• Question 132:

  When registering the RPA with a VNX to enable a VNX splitter for RecoverPoint, what failover mode must be set on the VNX?

  A. 1
  B. 2
  C. 3
  D. 4
  D. 4

• Question 133:

  Which RecoverPoint family is licensed per array and array capacity?

  A. RecoverPoint/EX only
  B. RecoverPoint/SE
  C. RecoverPoint/CL only
  D. RecoverPoint/EX and RecoverPoint/CL
  A. RecoverPoint/EX only

• Question 134:

  What is a characteristic of a volume sweep?

  A. Initialization is done on specific volumes in a Consistency Group.
  B. Initialization is done on all volumes in a Consistency Group.
  C. A volume sweep occurs when a user enables a disabled volume.
  D. A volume sweep occurs when a user enables a disabled splitter.
  A. Initialization is done on specific volumes in a Consistency Group.

• Question 135:

  Through what does RecoverPoint support heterogeneous storage environments?

  A. VPLEX
  B. Any array-based splitter
  C. APIs
  D. VMAX splitter only
  A. VPLEX

• Question 136:

  A company has just installed a RecoverPoint solution and configured it with two clusters. Which command will monitor system performance for both sites?

  A. export_statistics
  B. netstat -a
  C. balance_load
  D. config_io_throttling
  A. export_statistics

• Question 137:

  When adding a new vRPA, what is the only storage authentication method that is supported?

  A. CHAP
  B. iSNS
  C. RADIUS
  D. LDAP
  A. CHAP

• Question 138:

  When RecoverPoint is deployed with a VMAX splitter, what presents the virtual target and virtual remote devices?

  A. RPAs
  B. VMAX
  C. Switch
  D. Gatekeepers
  A. RPAs

• Question 139:

  A company has a RecoverPoint cluster in a remote replication environment that has several Consistency Groups. The Consistency Groups are constantly going into High Load. After reviewing the Unisphere for RecoverPoint event log, you

  see the following event:

  Journal is unable to handle the incoming data rate

  What should you review to identify the problem?

  A. Storage array performance of the remote site
  B. Storage array performance of the source site
  C. WAN link utilization
  D. RecoverPoint appliance performance of the source site
  A. Storage array performance of the remote site

• Question 140:

  A Consistency Group consists of one production copy, one local copy, and two remote copies. How many journals are required for this configuration?

  A. Four in total
  B. Two in total
  C. One for each remote copy and one for the local copy
  D. One for the production and one for each remote copy
  A. Four in total